Teledyne API - Model T200H/T200M Operation Manual Operating Instructions
105
Press the following buttons to select a communication mode for a one of the com ports,
such as the following example where HESSEN PROTOCOL mode is enabled:
Continu e pressing next un til …
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS C LK MORE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 HESSEN PRO TOCOL : OFF
PREV NEXT OFF ENTR EXIT
Continue pressing NE XT and/or PREV to select any other modes
you which to enable or disable
Use PREV and NEX
T
to
move bet ween avail able
modes.
A mode is enab led by
togglin g the ON/OF F
button.
Select wh ich COM
port to configure
EXIT ret urns
to the
previous
menu
ENTR accepts the new
settings
EXIT igno res the new
settings
The sum of the mode
IDs of the selected
modes is displayed
here
07270B DCN6512