Operating Instructions Teledyne API - Model T200H/T200M Operation Manual
128
4.13.1. ACCESSING THE DIAGNOSTIC FEATURES
To access the DIAG functions press the following keys:
SETUP X.X ENTER DIAG PASS: 818
8 1 8 ENTR EXIT
SETUP X.X PRIMARY SETUP ME NU
CFG DAS RNGE PASS CLK MO RE EXIT
SETUP X.X SECONDARY SETUP MENU
COMM VARS DI A
G
EXIT
From this point
forward, EXIT returns
to the
SECONDARY
SETUP MENU
DIAG SIGNAL I / O
NEXT ENTR EX IT
DIA
G
ANALOG OUTPUT
PREV NEXT ENTR EXIT
DIAG
A
NALOG I / O CONFIGURATION
PREV NEXT ENTR EXIT
DIAG DISPLAY SEQUENCE CONFIG.
PREV NEXT ENTR EXIT
DIAG ELECTRICA L TE ST
PREV NEXT ENTR EXIT
DIAG OZONE GEN OVERRIDE
PREV NEXT ENTR EXI T
EXIT returns
to the mai n
SAMPLE
display
DIAG OPTIC TEST
PREV NEXT ENTR EXIT
DIAG FLOW CALIBRATION
PREV NEXT ENTR EXI T
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
At this point EXIT
returns
to the PRIMARY
SETUP MENU
4.13.2. SIGNAL I/O
The signal I/O diagnostic mode allows to review and change the digital and analog
input/output functions of the analyzer. See Appendix A-4 for a complete list of the
parameters available for review under this menu.
Note Changes to signal I/O settings will remain in effect only until the signal I/O
menu is exited. Exceptions are the ozone generator override and the flow
sensor calibration, which remain as entered when exiting.
07270B DCN6512