Teledyne T200H/M

Getting Started Teledyne API - Model T200H/T200M Operation Manual

3.5.2. PNEUMATIC CONNECTIONS TO T200H/M BASIC CONFIGURATION

Figure 3-13 and Figure 3-14 show the most common configurations for gas supply and

exhaust lines to the Model T200H/M analyzer. Please refer to Figure 3-4 for the

locations of pneumatic connections on the rear panel and Table 3-2 for the descriptions.

Note Sample and calibration gases should only come into contact with PTFE

(Teflon) or glass or materials. They should not come in contact with FEP

or stainless steel materials.

Source of

SAMPLE GAS

Removed during

calibration

Instrument

Chassis

SAMPLE

EXHAUST

PUMP

MODEL T700

Gas Dilution

Calibrator

VENT (if no vent

on calibrator)

MODEL 701

Zero Gas

Generator

NOx Gas

(High Concentration)

VENT here if input

is pressurized

Figure 3-13: Pneumatic Connections–Basic Configuration–Using Gas Dilution Calibrator

07270B DCN6512