5.5.9 Removing/Replacing the Floppy Drive
To remove and replace the Floppy Drive, reference Figure 5-12 and perform
the following procedure:
1. Open up the base assembly as described in the previous paragraph
(Paragraph 5.5.6).
2. Remove the Keyscan Board as described in Paragraph 5.5.7.
3. Unlock the Zero Insertion Force connector holding the floppy cable to
the Main Board. Disconnect the Floppy Interface cable.
4. Using a No. 9 Torx head driver, remove the screw in the right front
corner of the notebook securing the drive to the base assembly.
5. Replacement is essentially the reverse of Steps 1 through 4 above.
Floppy Drive Assembly
Remove Keyboard Scan Board;
remove floppy connector from
Main Board
Remove two screws from ri ght
side of Floppy Drive
Figure 5-12 Floppy Drive, Removal/Replacement
5-18 Field Service