Texas Instruments TI-89, TI-92

Chapter 13: Tables 225

13TABLES.DOC TI-89/TI-92 Plus: Tables (English) Susan Gullord Revised: 02/23/01 1:08 PM Printed: 02/23/01 2:16 PM Page 225 of 10

To generate: tblStart @tbl Graph < - > Table Independent

n automatic table

¦ Based on

initial values

value value OFF AUTO

¦ That matches

Graph screen

—— ON AUTO

manual table — — — ASK

“—” means that any value entered for this parameter is ignored for

the indicated type of table.

In SEQUENCE graphing mode (Chapter 9), use integers for tblStart

and @tbl.

From the TABLE SETUP dialog box:

1. Use D and C to highlight the value or setting to change.

2. Specify the new value or setting.

To change: Do this:

tblStart

@tbl

Type the new value. The existing value is

erased when you start to type.

— or —

Press A or B to remove the highlighting.

Then edit the existing value.

Graph < - > Table

Independent

Press A or B to display a menu of valid

settings. Then either:

¦ Move the cursor to highlight the

setting and press ¸.

— or —

¦ Press the number for that setting.

3. After changing all applicable values or settings, press ¸ to

save your changes and close the dialog box.

You can set up a table’s parameters from the Home screen or a

program. You can:

¦ Store values directly to the system variables tblStart and @tbl.

Refer to “Storing and Recalling Variable Values” in Chapter 2.

¦ Set Graph < - > Table and Independent by using the setTable

function. Refer to Appendix A.

Which Setup

Parameters to Use

Changing the

Setup Parameters

Tip: To cancel a menu or

exit the dialog box without

saving any changes, press

instead of

From the Home

Screen or a Program