25
26
“P” Die
BPLT15BSCR-BBPLT15BSCR“U” Die
DA15-U Adapters
(Optional, see 6.3)
T&B Series 15600 Dies
TA03982 B Page 3 of 7
2.0 INSTRUCTIONS FOR USE
The tool can be easily carried using either the
handle or shoulder strap (19) attached to the
rings (27), see Fig 1 on page 2
With the tool at rest, proceed as follows:
• Select the appropriate die set for the
connector (Ref: Check Thomas & Betts
instruction sheet for the connector and make
sure color code of die matches color code of
connector )
• Insert one die into the die adaptor and one
die directly into the head
• Insert the conductor in connector
• Position the connector between the dies and
ensure the correct location of the crimp (See
connectors instruction sheet for number of
crimps )
Ensure that the dies are fully secured,
otherwise damage may occur during tool
operation.
PREPARATION (Refer to Figs 1, 2 & 3)
2.1
• Press the operating button (26) to activate the
motor-pump and advance the lower die To halt the
advancement, release the operating button (26) and the
motor will stop
Make sure the dies are exactly positioned on desired
crimp point, otherwise reopen dies following instructions
as per Step 2.5 and position the connector again.
DIE ADVANCEMENT (Refer to Fig 3)
2.2
Fig. 2
COMPRESSION
2.3
• By keeping operating button (26) pressed, the motor
continues to operate: the ram will gradually move forward
until the two dies touch
• It is recommended to continue pumping until the motor
stops automatically
• For ease of operation, the tool head can be rotated
through 180º, allowing the operator to work in the most
comfortable position
HEAD ROTATION
2.4
WARNING
Do not attempt to rotate the head when the hydraulic
circuit is pressurized.
• By pressing the pressure release button (25), the ram
will retract and open the dies
RELEASE OF DIES
2.5
Fig. 3
WARNING
When operating the tool, keep hands and other body parts
away from the danger zone.