Configure the following
❖Auto Split: This feature enables the chronograph to automatically take splits based on intervals (when you set intervals in Timer Mode), or by a distance, altitude, or a time you determine. For instance, you can configure the Watch to take a split every mile and then you can compare data for each mile in Lap Data Mode after you complete your activity.
❖Auto Start: This feature enables the chronograph to start when you start moving. It may take a few seconds for the GPS- 3D Sensor to detect your movement, causing a slight delay in start time.
❖Auto Stop: This feature enables the chronograph to stop when you stop moving. It may take a few seconds for the
NOTE: Even when enabled, you can still start and stop the chronograph manually and take manual splits without affecting the
❖Sync Timer & Chrono: This feature allows you to set the timer and the chronograph to start and stop simultaneously so you can record chronograph data when you use the timer.
You must turn the Sync Timer & Chrono setting off if you want the timer to switch to the Chronograph, Finish, or Vertical Mode at the end of a countdown in Timer Mode.
WATCH SETTINGS
Configure the following Watch settings:
❖Night Mode® feature: When enabled, the INDIGLO® night- light turns on when you press any button. This feature disables itself after eight hours.
❖Hourly Chime: When enabled, the Watch will chime at the top of every hour.
❖Button Beep: When enabled, the Watch will emit a beep when you press any button.
❖Mode Hiding: You can choose to show, hide, or disable the
following modes: Vertical, Finish, Lap Data, Summary, Timer, Navigate, Waypoints, or Alarm. For example, if you hide Navigate Mode, you will not see any information from this mode unless you are using the
66 | 67 |