TOA Electronics CST38MH installation instructions

DRAFT

05-23-06(2)

INSTALLATION INSTRUCTIONS MANUAL

36" Wood Burning Fireplaces

P/N 700,033M, REV. C, 12/2006

Model CST38MH

Retain These Instructions

For Future Reference

Report No. 116-F-20-4

This installation manual will enable you to obtain a safe, efcient and dependable installation of

your replace system. Please read and understand these instructions before beginning your

installation.

Do not alter or modify the replace or its components under any circumstances. Any

modication or alteration of the replace system, including but not limited to the

replace, chimney components and accessories, may void the warranty, listings

and approvals of this system and could result in an unsafe and potentially

dangerous installation.

IMPORTANT! TO ASSURE PROPER ALIgNMENT OF

gLASS dOORS: INSTALL THIS FIREPLACE IN A

SqUARE ANd PLUMB CONdITION, USINg

SHIMS AS NECESSARy AT SIdES ANd/OR

BOTTOM.

Contents

Main DRAFT INSTALLATION INSTRUCTIONS MANUAL 36" Wood Burning Fireplaces Model CST38MH Retain These Instructions For Future Reference Table of conTenTs PacKaGInG lIsT: safeTy rules: ImPorTanT: Please read and undersTand These rules To follow for safeTy. Tools and buIldInG suPPlIes normally requIred TyPIcal InsTallaTIon InTroducTIon General Information Table 1 chImney sysTem chimney height assembly ouTlIne before you start locaTIon of fIrePlace chimney enclosure assembly sTePs Pre-InsTallaTIon noTes clearances InsTallInG The fIrePlace ImPorTanT Figure 13 7" min. (178 mm) 23 " (608 mm) End View 42 " (1086 mm) 49" (1245 mm) 40 " (1022 mm) fIrePlace sPecIfIcaTIons notes Product reference Information Cat. No. Model Ship. Weight Ship. Volume framInG wall VarIaTIons InsTall The combusTIon aIr KIT Page Page Page Page Ten fooT rule summary fTf8 chImney comPonenT calculaTIons sPecIal offseT InsTrucTIons offseT eleVaTIon charT a c b stabilizer fTf8 VerTIcal eleVaTIon charT Table 4 offseT elbow assembly reTurn elbow assembly offseT calculaTIons InsTallInG offseTs Page hearth extensions and wall shields cauTIon ImPorTanT repack insulation material in square hole around gas line, interior and exterior, to seal. cold clImaTe InsulaTIon fIrePlace fInIshes mantels and Trim methods of determining hearth extension and wall shield equivalents - rM = r value per inch of alternate material rL = r value per inch of listed material TL = minimum thickness of listed material accessory ParTs and comPonenTs lIsT for model csT38mh fInIsh To your TasTe calculating minimum Thickness if multiple materials are used expanded explanation on calculating R val- ues when multiple materials are used. InsTallaTIon comPonenTs accessorIes and comPonenTs