November 2003 © TOSHIBA TEC 2 - 21 e-STUDIO3511/4511
ERROR CODE AND SELF-DIAGNOSTIC MODE
2.2 Self-diagnosis Modes
Mode
Control panel
check mode
Test mode
Test print
mode
Adjustment
mode
Setting mode
List print mode
PM support
mode
Firmware
update mode
Note:

To enter the desired mode, turn ON the power while two digital keys designated to each mode (e.g. [0]

and [5]) are pressed simultaneously.

<Operation procedure>

• Control panel check mode (01):

Notes:

1. A mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.

2. Button Check Buttons with LED (Press to turn OFF the LED.)

Buttons without LED (Press to display the message on the control panel.)

Button on touch panel (Press to display the screen on the control panel at power-

ON.)

[0][1]
[POWER]
(LED lit/LCD blinking)
[START]
[START]
(Button check)
[POWER] OFF/ON
(Exit)
For start
[0]+[1]+
[POWER]
[0]+[3]+
[POWER]
[0]+[4]+
[POWER]
[0]+[5]+
[POWER]
[0]+[8]+
[POWER]
[9]+[START]+
[POWER]
[6]+[START]+
[POWER]
[8]+[9]+
[POWER]
Contents
All LEDs on the control panel are lit, and all
the LCD pixels blink.
Checks the status of input/output signals.
Outputs the test patterns.
Adjusts various items.
Sets various items.
Prints out the data lists of the codes 05 and
08, PM support mode and pixel counter.
Clears each counter.
Performs updating of the system firmware.
For exit
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
[POWER]
OFF/ON
Display
100% C A4
TEST MODE
100% P A4
TEST PRINT
100% A A4
TEST MODE
100% D
TEST MODE
100% UA A4
LIST PRINT
100% K
TEST MODE