November 2003 © TOSHIBA TEC 6 - 27 e-STUDIO3511/4511 FIRMWARE UPDATING
(6) After the update is completed properly, the LED on the download jig blinks. The LED starts
blinking in approx. 15 sec. since the update starts. It is assumed that the update is failed if it does
not start blinking even though 1 min. has passed. In this case, turn OFF the power and check
the following items. Then, clear the problem and restart updating from the beginning.
• Is the download jig connected properly?
• Is the ROM installed to the download jig properly?
• Is the updating data written on the ROM of the download jig properly?
• Do the download jig and the equipment operate properly?
(7) Turn OFF the power, remove the download jig and install the RADF rear cover.