Using the remote control to operate a VCR or cable TV converter

•If you have a non-Toshiba VCR or cable TV converter or a Toshiba device that the remote control is not programmed to operate, you must first program the remote control to recognize your device.

•To use your TV remote control to operate a VCR, set the TV/CABLE/VCR switch to VCR. The shaded buttons in the picture below will then operate the VCR instead of the TV.

•To use your TV remote control to operate a cable TV converter, set the TV/CABLE/VCR switch to CABLE. The shaded buttons shown in the picture below will then operate the converter instead of the TV.

Point the remote control at the VCR or cable TV converter

Using the Control

RECALL MUTE

o

POWER

POWER

Remote

Channel Numbers

Press to directly access channels (as opposed to the Channel s/tbuttons).

TV/CABLE/VCR Switch

Set to CABLE to control the cable converter; set to VCR to control the VCR.

TV/VCR

To view one program while recording another, press to select TV mode.

REC

Starts tape recording.

SLOW

In play mode, press to view a slow-motion picture.

PAUSE

In play or record mode, press to freeze the picture; press again to release.

1 2 3

4 5 6

7 8 9

CH RTN

100 0 ENT

CH

VOL MENU/ VOL

ENTER

CH

TV

CABLE

VCR EXIT

FAV CH TV/VIDEO

A

REC TV/VCR STOP PLAY

STILL SOURCE PIP

SLOW PAUSE REW FF

PIP CH

LOCATE SWAP

CT-90037

Turns the VCR (or cable TV converter) on and off.

ENTER

Required by some VCRs and cable TV converters to change the channel.

CHANNEL s/t

sselects the next higher channel, and tselects the next lower channel.

STOP

Stops the tape.

PLAY

Begins tape playback.

FF

Fast-forwards the tape.

In play mode, press to view the picture moving rapidly forward.

REW

Rewinds the tape.

In play mode, press to view the picture moving rapidly backward.

12