Chapter 6: Using the TV’s features
56

Auto Setup

1無 Press and t or u to select the Setup menu.
2無 Press p or q to highlight Network Setup then
press .
3無 Press q to highlight Auto Setup, and then press
t or u to select On (default).
Network Setup
Auto Setup
IP Address
Subnet Mask
MAC Address
On
255 . 255 . 255 . 0
133 . 123 . 108 . 157

Manual Setup

This setup requires the data listed below. You can get
this data from either your ISP or the configuration
utility for your DSL/cable modem or router.
1無 Press and t or u to select the Setup menu.
2無 Press p or q to highlight Network Setup, and
then press .
3無 Press q to highlight Auto Setup, and then press
t or u to select Off.
4無 Press q to highlight IP Address field, and then
use the Number buttons on the remote control to
input the IP Address.
5無 Press q to highlight the Subnet Mask field, and
then use the Number buttons to input the Subnet
Mask.
6��� Press .
Setting the sleep timer
You can set the sleep timer to turn off the TV after a
set length of time (maximum of 180 minutes).

To set the sleep timer using the remote control:

Press on the remote control to set the length of
time until the TV turns off. Repeatedly press to
increase the time in 10-minute increments, or press
p or q to increase or decrease the time in 10-minute
increments, to a maximum of 180 minutes.

To set the sleep timer using the on-screen

menus:

1無 Press and open the Setup menu.
2無 Highlight Sleep Timer and press .
3無 Press the Number buttons to enter the length of
time in 10-minute increments.
4無 Highlight Done and press .
Note: When a power failure occurs, the
sleep timer setting may be cleared.

To display the remaining sleep time:

Press .
Note: A message will display on-screen when
there is one minute remaining on the sleep timer.

To cancel the sleep timer:

Repeatedly press until it is set to 0 minute.
Using REGZA-LINK®
This is a new feature that uses CEC technology
and allows you to control Toshiba REGZA-LINK
compatible devices from the TV remote via HDMI
connection ( page 17).
When the Enable REGZA-LINK in the REGZA-
LINK setup menu ( page 57) is set to On, the
following REGZA-LINK functions will be enabled.

REGZA-LINK® playback device (DVD

player, etc.) control

With your TV��s remote control, or using the REGZA-
LINK Player Control menu, you can control the
connected REGZA-LINK playback device you are
watching.

Available remote control key functions:

Before using the following key functions, first set the
MODE SELECT switch on the remote control to TV.
Button Description
Begins playback.
Stops playback.
Pauses the picture during play or record
mode.
Skips forward.
Skips backward.
(continued)