To control a cable TV converter:
Program the remote control to recognize the brand of your converter. The shaded buttons shown at right will control the cable TV converter.
Set the TV/CABLE/VCR switch to the CABLE position.
Programming the remote control for use with a VCR or a cable TV converterThis remote control is
1.Refer to the “VCR code table” or “Cable TV converter code table” on pages
If more than one number is listed, try each one separately until you find the one that works.
2.If you are reprogramming the remote control to operate your:
•VCR, set the TV/CABLE/VCR switch on the remote control to VCR.
•Cable converter, set the TV/CABLE/VCR switch on the remote control to CABLE.
3.While holding down the RECALL button, press the Number buttons
4.Point the remote control at the VCR or converter and press POWER to test the code.
If the VCR or converter turns on, you have entered the correct code.
If the VCR or converter does not respond to the remote control, you may have entered the wrong code. Repeat steps
5.Reset the TV/CABLE/VCR switch to TV to control the TV.
For future reference, write down the code numbers you used:
VCR code | _____________________ |
Cable code | _____________________ |
|
|
|
| RECALL |
| LIGHT | RECALL POWER |
| |
TV |
|
|
| POWER |
|
|
|
| |
CABLE | MUTE | TV/VIDEO TIMER |
| |
VCR |
| |||
|
|
|
| |
1 | 2 | 3 |
| Channel yz |
|
|
| CH | |
4 | 5 | 6 |
| Channel |
7 | 8 | 9 |
| |
| Number | |||
|
| CH RTN | VOL | |
|
|
| ||
100 | 0 | ENT |
| Enter |
|
|
|
| |
| ADV/ |
|
| |
FAVORITE | PIP CH | PIC |
| |
|
|
| ||
|
|
| SIZE |
|
FAV | MENU/ | FAV |
| |
ENTER |
| |||
|
|
| ||
STROBE | ADV/ | EXIT |
| |
| PIP CH |
|
| |
STOP SOURCE | PLAY PIP |
| ||
REC | TV/VCR | REW | FF |
|
Note:
•Each timeSTILLyouLOCATEreplaceSWAP the batteries, you must reprogram the remote control.
•Some newer VCRs are capable of working on either of two remote codes. These VCRs have a switch labeled “VCR1/VCR2.”
If your VCR has this kind of switch, it may not respond to any of the code numbers for your VCR brand name. In this case, set the switch to the other position (VCR1 or
VCR2) and reprogram the remote control.
Introduction |
|
|
|
|
|
Connecting | yourTV |
|
|
|
|
Usingthe | RemoteControl |
|
|
|
|
Settingup | yourTV |
|
|
|
|
UsingtheTV’s | Features |
|
|
|
|
Appendix |
|
|
|
|
|
Index |
|
|
|
15