12
Moving the drainage hose The drainage hose can be installed on either the right or left side.
The connector port for the drainage hose is found on the right side of the washing machine, but it can be changed without
disconnecting the internal hose from the drainage valve.
1Remove the back cover, then
grip the stopper securing the
internal hose with your fingers
and pull it up.
2Turn the nut for the drainage
hose connector port
counterclockwise.
3Pull the internal hose from
inside the washing machine to
detach.
4Remove the hose hole cap on
the left-hand side, from inside
the washing machine align the
internal hose with the notch in
the connector port and fit into
place, then from outside put the
nut in place and turn clockwise
to secure.
5Turn the stopper 180°C without removing from
hose. Insert the stopper into the securing hole
on the left side of the outer shell and press
down to secure the internal hose.
6Attach the back cover, and fit the hose hole
cap over the hose hole on the right-hand side.
7After moving the drainage hose, be sure to
testoperate the washing machine, ensuring
that there are no water leaks or unusual
noises.
Stopper
Nut
Drainage valve
Stopper
Installing the drainage hose

Moving the hook

When inserting the drainage hose into a wash pan or
onto a drain pipe, the hook may be moved to facilitate
the installation.
When hooking the hose hook
into the slot provided on the
body of your washing machine,
move the hook back to its initial
position.
Insert the drainage hose
in as far as it will go, then
use the accessory hose
band to secure it tightly.
Secure the hose tightly.
An improperly secured
hose may cause leakage.
When attaching the drainage
hose to a wash pan, etc.,
either leave a gap between
the end of the hose and the
adjacent surface, or cut the
hose diagonally to ensure
proper drainage.
Allowing the flat end of the
hose to come in contact
with the flat surface of the
washing machine will
impair drainage.
Caution:
If the level of the threshold and the drainage hose is high,
the washing machine may not be drained.
Be careful not to rub the drainage hose. Do not insert the
drainage hose under the washing machine. They may be
damaged the drainage hose.

Drainage hose extension

Pay close attention to the height of the drainage hose and
articles over which it passes. If the drainage hose is too
high, proper drainage may not be obtained.
The length of the
drainage hose may be
extended to as much
as 3 m if kept the same
level.
Drainage
hose
Concrete block
3 m or less
Drainage hose cap
Hook
Drainage hose
Gap 3 cm or
greater
Cut diagonally
Drainage hole
15 cm or less
Tap
Hose hole cap
Upper and lower notches
in the hose hole
Nut
Outer shell
INSTALLATION
Drainage hose
Drain pipe
Hose band
Installing the ground pin
The ground pin in the plug should be connected to the proper point of the socket for grounding.
6348100701 (11-15) 22/10/08, 11:1912