4.17 LCD Module and CCD Board 4 Replacement Procedures
Satellite/Satellite Pro/L650 Maintenance Manual 4-45
4.17 LCD Module and CCD Board NOTE: ICs are fragile. Use extreme care not to apply pressure to the ICs along the
edges of the LCD module.
NOTE: Dispose of used LCD panels (fluorescent (FL) tubes) as required by local
ordinances or regulations.
NOTE: The LCD/FL cable must be carefully peeled away before disconnecting it from the
module.
Removing the LCD Module and CCD Board
Remove the LCD Module and CCD Board according to the following procedures and
Figures 4-26, 4-27.
1. Remove the CCD module with CCD cable from display rear cover.
2. Disconnect the CCD cable from the CCD module connector.
3. Remove two M2.5x5 black flat head screws on each side securing the LCD bracket.
4. Carefully tilt the LCD module toward you.
5. Remove three M2x3 black flat head screws on each securing the LCD bracket.
6. Remove the LCD brackets.
7. Turn the LCD upside down. Be sure to place it on a cushioned surface such as a foam
pad.
8. Remove the tape and LCD cable connector. Then disconnect the LCD cable.