Toshiba 3006GAL, 4006GAH, MK6006GAH manual 82

360050398

Table 10.8-4 Identify Information (Continued)

WORD			DESCRIPTION	Hex.
87	Command set/feature default			6023
	15	0 (Fixed)
	14	1 (Fixed)
	13	1 (Fixed)
	12-6	Reserved
	5	1=General Purpose Logging feature set supported
	4	Reserved
	3	1=Media Card Pass Through Command feature set enabled
	2	1=Madia serial number is valid
	1	1=SMART self-test supported
88	15-8	Ultra DMA transfer mode selected		XX3F
	7-0	Ultra DMA transfer modes supported
89	Time required for security erase unit completion			00XX
90	Time required for Enhanced Security erase completion			0000
91	Current Advanced Power Management setting			00XX
	15-8 Reserved
	7-0 Current Advanced Power Management setting set by Set Features
		Command
92	Master Password Revision Code			XXXX
93	Hardware reset result. The conetnts of bits 12-0 of this word shall change only			XXXX
	during the execution of a hardware reset.
	15	0 (Fixed)
	14	1 (Fixed)
	13	1=device detected CBLID- above VIH
		0=device detected CBLID- below VIL
	12-8 Device 1 hardware reset result. Device 0 shall clear these bits to
		zero.
		Device 1 shall set these bits as follows :
		12	Reserved.
		11	0=Device 1 did not assert PDIAG-.
			1=Device 1 asserted PDIAG-.
		10-9 These bits indicate how Device 1 determined the device
			number:
			00=Reserved.
			01=a jumper was used.
			10=the CSEL signal was used.
			11=some other method was used or the method is
			unknown.
		8	1 (Fixed)
	7-0 Device 0 hardware reset result. Device 1 shall clear these bit to
		zero.
		Device 0 shall set these bills as follows:
		7	Reserved.
		6	0=Device 0 does not respond when Device 1 is selected.
			1=Device 0 responds when Device 1 is selected.
		5	0=Device 0 did not detect the assertion of DASP-.
			1=Device 0 detected the assertion of DASP-.
		4	0=Device 0 did not detect the assertion of PDIAG-.
			1=Device 0 detected the assertion of PDIAG-.
		3	0=Device 0 failed diagnostics.
			1=Device 0 passed diagnostics.
		2-1	These bits indicate how Device 0 determined the device
			number:
			00=Reserved.
			01=a jumper was used.
			10=the CSEL signa was used.
			11=some other method was used or the method is
			unknown.
		0	1 (Fixed)
94	Current automatic acoustic management value			0000
	15-8	Vendor’s recommended acoustic management value
	7-0	Current automatic acoustic management value
95-99	Reserved			0000
100-103	Maximum user LBA for 48-bit Address feature set			XXXX
104-126	Reserved			0000

Toshiba Corporation Digital Media Network Company

Page 82 of 157

© 2005, Copyright TOSHIBA Corporation All Rights Reserved