5.Remove back cover of speed control housing by removing the three screws securing it to the housing. See Fig. 6-4.

7.Using a pair of needle nose pliers or similar tool, move eyelet in cable only one slot to the left in housing as shown in Fig. 6-5.

Figure 6-4

6.Remove screw and flat washer securing cable. See Fig. 6-4.

NOTE: Make sure to take note of which slot in housing cable is in.

Figure 6-5

NOTE: Moving eyelet to the left speeds unit up; moving it to the right slows it down.

8.Replace screw and washer removed earlier. Reassemble back of housing. Reattach battery harness assembly to the speed control housing, making sure to snap the tab on the harness into the slot on the housing. See Fig. 6-3. Secure with the three screws removed earlier.

Section 6 — Maintenance & Adjustments

 

15