OPERATING INSTRUCTIONS
HOLDING THE TRIMMER
WARNING: Always wear eye, hearing, foot and
body protection to reduce the risk of injury when operating this unit.
Before operating the unit, stand in the operating position (Fig. 27). Check for the following:
•The operator is wearing eye protection and proper clothing
•With a
•The operator’s left arm is straight, the left hand holding the handle
•The unit is at waist level
•The cutting attachment is parallel to the ground and easily contacts the grass without the need to bend over
Fig. 27
ADJUSTING TRIMMING LINE LENGTH
The Bump Head™ cutting attachment allows you to release trimming line without stopping the engine. To release more line, lightly tap the cutting attachment on the ground (Fig. 28) while operating the trimmer at high speed.
NOTE: Always keep the trimming line fully extended. Line release becomes more difficult as the cutting line becomes shorter.
Each time the head is bumped, about 1 inch (25.4 mm) of trimming line is released. A blade in the cutting attachment shield will cut the line to the proper length if excess line is released.
For best results, tap the Bump Head™ on bare ground or hard soil. If line release is attempted in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult as the cutting line becomes shorter.
NOTE: Do not rest the Bump Head™ on the ground while the unit is running.
CAUTION: Do not remove or alter the line cutting blade
assembly. Excessive line length will make the clutch overheat. This may lead to serious personal injury or damage to the unit.
Fig. 28
Some line breakage will occur from:
•Entanglement with foreign matter
•Normal line fatigue
•Attempting to cut thick, stalky weeds
•Forcing the line into objects such as walls or fence posts
TIPS FOR BEST TRIMMING RESULTS
•For best trimming results, operate unit at full throttle.
•Keep the cutting attachment parallel to the ground.
•Do not force the cutting attachment. Allow the tip of the line to do the cutting, especially along walls. Cutting with more than the tip will reduce cutting efficiency and may overload the engine.
•Cut grass over 8 inches (200 mm) by working from top to bottom in small increments to avoid premature line wear or engine drag.
•Cut from right to left.
•Slowly move the trimmer into and out of the cutting area at the desired height. Move either in a forward- backward or
•Trim only when grass and weeds are dry.
•The life of your cutting line is dependent upon:
•Proper adherence of explained trimming techniques
•What vegetation is cut
•Where vegetation is cut
For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree.
DECORATIVE TRIMMING
Decorative trimming is accomplished by removing all vegetation around trees, posts, fences and more.
Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 29).
Fig. 29
12