MAINTENANCE INSTRUCTIONS
EZ ADVANCE STRING HEAD REPLACE THE SPOOL OF NYLON LINE
1.Unplug the trimmer.
2.Remove the spool assembly from the trimmer. To do so, hold in two cap release latches with one hand. Pull cap away from the hub. (Fig.21). Remove spool.
Fig. 21
3.Using 2 pieces of .080" replacement line measure off approximately 10.5’ of line. Put 2 lines into 2 slots of the spool. (Fig. 22).
Fig. 22
4.Wind the line onto the spool by turning the spool as the arrows shown in Fig. 23.
5.Line should be wrapped snugly around the spool. Wind it until there is about 4" of line left. Be sure to not twist or cross line when winding.
6.Lock the ends of the lines in the notches of the spool. (Fig.24)
Fig. 24
Fig. 25
7.Insert the line through each eyelet in the hub. (Fig.25) Straighten the lines by removing from notches.
8.Make sure lines feed smoothly.
9.Replace cap securely on hub.
10.In the event of the line breaking inside the spool, repeat the replacement operation.
11.Start the grass trimmer following the instructions in the “BEFORE STARTING THE UNIT” section.
Fig. 23
16