Attaching the Chute Attachment

WARNING! DO NOT operate without shields and guards (e.g., discharge chute, air intake guard) in place.

To redirect airflow at a 90 degree angle during operation, a chute attachment is included with your jet sweep blower.

1.Pivot the blower direction lever all the way to the right, into the highest position. See Fig. 3-3.

2

1

3

 

 

 

Figure 3-3

2.Slide the chute attachment downward, over the opening.

3.Pivot the direction lever to the middle position to lock the chute attachment in place. See Fig. 3-3.

WARNING! Keep hands out of inlet and discharge openings while machine is running. There are rotating blades inside.

Set-Up

Adding Fuel

Refer to the Engine Operator’s Manual packed with your jet sweep for information on adding fuel.

Warning! Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition.

Adding Oil

Refer to the Engine Operator’s Manual packed with your jet sweep blower for information on adding and checking oil.

Caution: Always check the engine oil level before each use as instructed in the Engine Operator’s Manual. Add oil as necessary. Failure to do so may result in serious damage to your engine.

Section 2 — Assembly & Set-Up

 

7