ASSEMBLY INSTRUCTIONS

HANDLE ASSEMBLY

Self-Tapping

1.

Remove the unit from the box.

2.

Place the 2-holed end of the straight metal shaft over the

 

shaft base on the unit and align the holes (Fig. 1).

3.

Insert the two self-tapping screws (1/4” x 1-1/4”) into these

 

holes (Fig. 1).

4.

Using a 3/8” wrench, screw each self-tapping screw into

 

the shaft until firm. DO NOT OVERTIGHTEN.

5.

Insert the control handle onto the 3-holed end of the

Screws

Bolts

straight metal shaft and align the control handle’s holes

with the two end holes of the straight metal shaft (Fig. 2).

NOTE: Because the control cables are pre-installed, care must be taken when installing the control handle to not pinch or bend the cables. This can damage them and cause them to function improperly.

6.Insert the two screws (1/4” x 1-1/2”) into the recessed hex holes on the handle (Fig. 2) and hold in place.

7.Hand-start the lock-nuts onto these bolts.

8.Using a 7/16” wrench, tighten each nut onto each bolt until firm.

9.Pull out the starter rope and run it into the eye hook (Fig. 3).

10.Insert the eye hook into the remaining hole on the straight metal shaft (Fig. 3).

11.Screw the nut onto the eye hook (Fig 3) and use a 7/16” wrench to tighten. DO NOT OVERTIGHTEN.

12.Using the zip tie in the hardware bag, secure the handle cables to the straight metal shaft mid-way between the eye hook and the motor housing.

Lock-Nuts

Fig. 1

Fig. 2

Starter Rope Handle

Eye Hook

Starter Rope

Lock-Nut

Fig. 3

5