16
http://www.TYAN.com
2.20 – Mounting the Motherboard
Before installing your motherboard, make sure your chassis has the necessary motherboard
support studs installed. These studs are usually manufacturer pre-installed, metal and are gold in
color. If you are unsure of stud placement, lay the motherboard inside the chassis and align the
studs.
NOTE YOU MUST make sure that there are no studs where there are no screw holes.
2.21 – Installing the Memory
Before attempting to install any memory, here are a few key points to note before installing
memory modules onto your board.
• Memory modules must be installed in pairs (DIMM1+DIMM2 or DIMM3+DIMM4)
• At least two unbuffered DDR ECC/non-ECC modules must be installed
• All installed memory will be automatically detected - no need to set any jumpers
• Supports 128MB, 256MB, 512MB and 1GB unbuffered DDR200/266 modules
• Supports up to 4GB of memory
DIMM1 + DIMM2
Or
DIMM3 + DIMM4
Or
DIMM1 + DIMM2 +
DIMM3 + DIMM4
DDR Unbuffered Non-ECC
v supported
DDR Unbuffered ECC
v supported
DDR Registered ECC