Glossary
Glossary or Terms
This list provides brief descriptions of various terms relating to this publication:
ABSORPTION COEFFICIENT – The ratio of
“A” WEIGHTED DECIBEL – The ear is less sensitive to low frequency pitch at low volume levels, the “A” weighted correction curve is applied to SPL measurements to equalize the loudness of sounds over the hearing range. Meters configured with the “A” weighted filter read out in units of dBA, short for “A” Weighted Decibel.
AHJ – The “Authority Having Jurisdiction” is the organization or person responsible for approving fire alarm installations for occupancy.
AUDIBILITY – A measure of loudness of a sound. When used with respect to fire alarm systems, audibility is regarded as the evacuation signal level above background noise.
CIS – The “Common Intelligibility Scale” is a standardized scale that correlates a variety of intelligibility measurement methods.
CLIPPING – When part of the electrical signal path exceeds the capacity of the component audio “Clipping” can occur, causing a reduction in intelligibility.
COMBINATION SYSTEM – A fire alarm system that is also used for
COMMAND CENTER – The area of a building (usually near the entrance) that acts as the communications center for emergency personnel. The command center is used to display the fire alarm system status and control the annunciation system. This area typically includes the equipment required to generate and distribute messages throughout the building’s fire alarm audio network.
CONSTANT VOLTAGE – Speakers used for a distributed emergency evacuation system are wired as a “Constant Voltage” system, where the voltage at each speaker is the same (typically 25V or 70.7V) at the maximum power output of the amplifier.
COVERAGE ANGLE – The angle where the speaker Sound Pressure Level (SPL) drops 6 dB from the
COVERAGE AREA – The plane where the Sound Pressure Level (SPL) at the edge of the plane drops 6 dB below the
CRITICAL POLAR ANGLE – The angle where the sum of the distance loss and the polar loss is 6 dB less than the
DECIBEL – A unit used to express relative difference in power, usually between acoustic or electric signals, equal to ten times the common logarithm of the ratio of two power levels or 20 times the common logarithm of the ratio of two voltage levels.
DIGITAL RISER – A digital system that transmits multiple channels of digital audio throughout a facility. A single pair of wire is used to transmit up to eight channels of digitally encoded audio signals. The digital riser is considered a signaling line circuit, and is wired in a Style 4 or Style 7 configuration.
DIRECTIVITY FACTOR “Q” – A common representation of speaker directivity for speakers having a conical coverage pattern (typical of single driver speakers used in fire alarm applications). Q is determined by an equation covered in Chapter 2 of this manual.
Continued on next page
