Unisys EFP9800 manual Sensor Status, Bit Sensor

EFP9800 ESC/POS Commands

Select Paper Sensor(s) to Stop Printing

Selects the paper sensor(s) used to stop printing when the paper-end is detected. The printer finishes printing the current line and feeds the paper before stopping. After a paper sensor is enabled, printing is stopped only when the corresponding paper is currently selected. If multiple sensors are enabled, printing stops when any one detects a paper end.

When the DSW2-3 (DIP switch) is set to Off and the journal paper sensor signals a paper end, the printer goes offline after printing stops. When the slip sensor is enabled and there is not enough paper for the next print instruction, the printer ejects the paper and enters the paper waiting state.

Hexadecimal	Decimal	ASCII
1B 63 34 n	27 99 52 n	ESC c 4 n

		Sensor Status
Bit	Sensor	0	1
0	Receipt/Journal Paper Near-End	Disabled	Enabled
1	Receipt/Journal Paper Near-End	Disabled	Enabled
2-4	Undefined
5	Slip (Detects Slip Ejection)	Disabled	Enabled
6	Undefined
7	Validation (Detects Validation Ejection)	Disabled	Enabled

6– 24 3255 4073– 002