Product Features

Safety Pilot

This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent-free room fireplaces. The ODS/pilot shuts off the fireplace if there is not enough fresh air.

Thermostatic Heat Control

This fireplace has a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater fireplace comfort. This can also result in lower gas bills.

Piezo Ignition System

This fireplace has a piezo ignitor. This system requires no matches, batteries, or other sources to light fireplace.

Unpacking

1.Remove fireplace and hood from carton. Log is wrapped and inside fireplace. Do not remove at this time.

2.Remove all protective packaging applied to fireplace for shipment.

3.Make sure your fireplace includes one hardware packet.

4.Check fireplace for any shipping damage. If heater is damaged call DESAHeating, LLC at 1-866-672-6040 for replacement parts before returning to dealer.

Assembly

WARNING: Always have branch support and screen in place before operating fireplace. Thispreventsexcessivetemperatures on fireplace surfaces.

WARNING: Failure to position thepartsinaccordancewiththese diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.

Assembling Fireplace

Tools Required:

Phillips screwdriver

5/16" hex wrench

slotted screwdriver

Installing Log

1.Lift screen up and pull out to remove.

2.Cut two plastic straps to remove the log from the firebox cavity.

3.An optional blower is available. See Ac- cessories, page 29. Install optional blower now. Follow installation instructions pro- vided with blower.

4.Remove log packaging material and discard packaging. Gently place log set on burner support (see Figure 2). The log should fit flat against top of burner sup- port and log locator tabs fit into the slots under the log. Do not allow log to contact flame. If flame contacts log, soot will be created.

5.Reattach screen by placing the notches in the screen frame over the shoulder screws and pushing down.

Log

Shoulder

Burner Support

with Log

 

Screw

Locator Tabs

 

 

Screen

Branch

Support

Figure 2 - Assembling Fireplace

113111-01H

www.desatech.com

5