Vertex Standard FT-2000 manual 17

PLUG/CONNECTOR PINOUT DIAGRAMS

MIC	CAT	DC IN
UP	N/A
	SERIAL OUT
+5V
	SERIAL IN
DOWN
	N/A
FAST
	GND
GND
	N/A
PTT
	RTS
MIC GND
	CTS
MIC
	NC
(as viewed from front panel)	(as viewed from rear panel)	(as viewed from rear panel)
BAND DATA	PACKET	RTTY
+13V
TX GND	DATA IN
GND		SHIFT
	GND
BAND DATA A		RX OUT
	PACKET PTT
BAND DATA B		PTT
	DATA OUT
BAND DATA C		GND
	BUSY
BAND DATA D
LINEAR
(as viewed from rear panel)	(as viewed from rear panel)	(as viewed from rear panel)
ROT (ROTATOR)	PHONE	RCA PLUG
CW ROTATION	SUB (VFO-B)	GND or (---)
CCW ROTATION
SPEED
DIRECTION
GND
NC
	MAIN (VFO-A) GND	SIGNAL or (+)
(as viewed from rear panel)
REM (REMOTE)	AF OUT	EXT SPKR
GND	SUB (VFO-B)	GND

SIGNAL MAIN (VFO-A) GND SIGNAL

	KEY
For Internal Keyer	For Straight Key

DOT DASH COMMON KEY GND

Do not use

2-conductor type plug

IMPORTANT NOTE:

The µ-TUNE, DMU, and PGM connectors are special connectors for this transceiver. Please do not connect any accessory or other device not specifically approved by Vertex Standard. Failure to observe this precaution may cause damage not covered by the Limited Warranty on this apparatus.

FT-2000 OPERATING MANUAL Page 15