6
ViewSonic PJ860
E
N
G
L
I
S
H

Operation

b
a
1Power ON the projector. Set the MAIN POWER switch to ON (located
on the side Connector Panel). The ON indicator lights orange.
2Press the STANDBY/ON button on the Projector Control Panel or on
the Remote Control Unit. (See page 7.)
The ON indicator blinks green during warm-up and stays green
when projector is ready for use.
NOTE: The power can not be turned on if the STANDBY/ON button
is pressed within 60 seconds after the power is turned off.
3Remove the lens cap.
4Position the projector the desired distance from the projection
screen, then set the projection angle by positioning the foot
adjusters. (See

Positioning the Projector

and

Setting the Projection

Angle

below.)
5Power ON all connected input devices. (See page 5.)
6Select the signal source: press the INPUT button on the projector or
one of the INPUT buttons (VIDEO/RGB) on the Remote Control Unit.
(See page 7.)
NOTE: To switch between RGB1 and RGB2, use the INPUT
menu (see page 10).
7Using buttons on the Remote Control Unit or the control panel on top
of the projector, adjust the picture size with the ZOOM button, then
adjust the focus using the FOCUS button.

The projector must be horizontal to get a distortion-free picture. Place the projector on a table-top or other flat

surface. Use the chart below to determine the placement of the projection screen.

Positioning the ProjectorSetting the Projection Angle
Front View
Side View
Side View
Top View
a = distance from projector
to screen
b = distance from center of
lens to bottom of screen
(a, b: +/- 10%)
1While firmly grasping the front of the projector with both hands, use
your index finger to push --and hold-- the Adjuster Buttons (located on
the sides of the projector).
2While pressing the Adjuster Buttons, tilt the front of the projector up in
order to adjust the viewing angle. Then (while still grasping the
projector) 8 1 Tc1the fro 0  theo 0  Adjusteloksing the frone
ole fine adjusemeness, urfront Adjustess.n