Maintenance Instructions
ADJUSTMENTS/ ELECTRICAL SYSTEM
ADJUSTMENTS
Steering Levers
An adjustment range of approximately 3 inches is available on the steering levers - the levers can be adjusted forward or aft depending on the arm length of the operator. The levers can be adjusted by loosening the locknut at the pivot point and the locknut holding the lever in position in the adjustment slide. Adjust levers into most comfortable position and tighten both locknuts.
Locknut
Adjustment(Position)
Slide
Locknut
(Pivot Point)
Steering Lever Adjustment
When the carrier frame hinge joint is properly ad- justed, the deck lock levers should move in and out of the engaged and disengaged positions freely. All four hitch pins used for height adjustment should sit flush on the washers above the deck pin bushing. On a level surface, if any pin is sticking up (likely the front pins), tighten the opposite side or loosen the same side to lower the pin. Adjustments are made by loosening the jam nut and tightening or loosening the set screws on the Deck Mount Pivot Brack- ets. Retighten the jam nut when the adjustment is complete.
Jam Nut
Set Screw
ELECTRICAL SYSTEM
For troubleshooting, refer to the Wiring Diagram.
IMPORTANT: Disconnect both battery cables before unplugging any wiring connectors or making repairs on the electrical system.
51