Operating Instructions
Transmission Lockout Levers
The transmission lockout levers disengage the hydrostatic transmissons. By lifting the lever on top of the transmission and locking it into place with the lockout cam, the hydrostatic transmissions are released to permit freewheeling. By releasing the cam and lowering the lever, the transmissions are engaged for normal operation. The transmission lever in the LOCKOUT position is used to enable moving the machine without the engine running (e.g., for service). Refer to TRANSMISSION LOCKOUT in this section for operating instructions.
Lockout
Levers
Transmission
Plunger
Lockout Lever Location
NOTE: The transmission plunger on the side of the transmission case (activated by the LOCKOUT LEVER ) must be completely released during operation of the mower, otherwise operation of the transmission will be erratic.
Cold Start Lever (Jackshaft Drive Belt Release)
The cold start lever is used for starting the machine in cold weather [below 40° F (4° C)]. Pulling the lever DOWN disengages the jackshaft drive belt. When the jackshaft drive belt is released, the hydrostatic transmissions are removed from the engine starter cranking load.
Jackshaft Drive
Engaged
Cold Start Lever - Normal Operating Position
Jackshaft Drive
Disengaged
Cold Start Lever - Cold Start Position
27