Maintenance Instructions | ADJUSTMENTS |
2.If one wheel is moving too fast, bring the mower back into NEUTRAL (using the FSC switch) and slightly tighten the adjustment bolt on the speed control actuator on the side that is moving faster.
Tighten Bolt to
Slow Down
Travel Speed
Tracking Adjustment
Control Handle (Pistol Grip) Adjustment - Step 5
1.Loosen jam nut and adjust upper ball joint on upper lever linkage to achieve a 1" gap between control handle and pistol grip.
2.Make identical adjustment to the other side of handle. It may be necessary to adjust both wheels in order to achieve tracking and neutral.
Use Ball Joint
End to Adjust
Pistol Grip Position Adjustment
Handlebar Height Adjustment
The height of the handlebar position for operators can be adjusted (taller for taller operators, shorter for shorter operators) using the following steps:
1.Unbolt the handlebar connection at the body on both sides. Unbolt the steering control arms.
2.Reattach handlebar and control arms in corre- sponding holes.
Handle Bar
Attachment to Body
Adjustable Steering
Control Rod
Handlebar Height Adjustment
Jam Nut
Set Screw
When the carrier frame hinge joint is properly adjust- ed, the deck lock levers should move in and out of the engaged and disengaged positions freely. All four hitch pins used for height adjustment should sit flush on the washers above the deck pin bushing. On a level surface, if any pin is sticking up (likely the front pins), tighten the opposite side or loosen the existing side to lower the pin. Adjustments are made by loosening the jam nut and tightening or loosening the set screws on the Deck Mount Pivot Brackets. Retighten the jam nut when the adjustment is com- plete.
46