Weider WEBE15100 manual Tubes and Backrest must be oriented exactly As shown

7.	Press four 1Ó Square Inner Caps (12) into the	7
	Backrest Tubes (5, 55). Press two 1Ó x 2Ó Inner
			6
	Caps (45) into the adjustment tubes.	Wide
				12
		End
	With the wide end of the Backrest (6) positioned
	as shown, attach the Backrest Tubes (5, 55) to
	the Backrest (6) with four M6 x 38mm Screws
	(16) and four M6 Washers (25). The Backrest	5		25
	Tubes and Backrest must be oriented exactly
	as shown.			55
				16
		12	25	Adjustment
			16	Tubes
				25
			45	16
8.	Lubricate the M10 x 178mm Bolt (17). Attach the	8	6
	Backrest Tubes (5, 55) to the Frame (2) with the
	Bolt, two M10 Washers (24), and an M10 Nylon
	Locknut (19). Do not overtighten the Locknut. The
	Backrest must be able to pivot freely.		5
	Secure the Backrest Tubes (5, 55) to the Frame	40	55
	(2) by inserting the Adjustment Pin (40) through			Adjustment
	one of the three sets of holes in the adjustment	17ÑLubricate		Tubes
	tubes. Secure the Adjustment Pin with the Pin		24
	Clip (57).
	Make sure the Adjustment Pin (40) is com-
	pletely inserted through both adjustment		19	2
	tubes.			57
9.	With the wide end of the Seat (11) positioned as	9	11
	shown, attach the Seat to the brackets on the
	Frame (2) with four M6 x 16mm Screws (15).	Wide
		End
				2
				15
10.	Attach the Curl Pad (28) to the Curl Post (27) with	10
	two M6 x 16mm Screws (15).
			28
				15
				27
		8