27
PRODUCT DATA SHEETS

Base Grille Water Filtration System

Model WF-NL240/NL240 Capacity 240 Gallons (908 Liters)

Model WF-L400/L400 Capacity 400 Gallons (1514 Liters)

This system has been tested according to ANSI/NSF 42/53 for the reduction of the substances listed below. The concentration of
the indicated substances in water entering the syste m was reduced to a concentration less than or equal to the permissib le limit for
water leaving the system, as specified in ANSI/NSF 42/53.
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 63°F
(17.2°C).
It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product to
perform as advertised.
Model WF-NL240 Change cartridge at least every 6-9
months. Use replacement cartridge NL240, part# 4396508.
2003 suggested retail price of $32.99 U.S.A./$49.95 Canada.
Prices are subject to change without notice.
Model WF-L400 The filter monitor system measures the
amount of water that passes through the filter and alerts you
to replace the filter. When 90% of the filters rated life is used,
the filter indicator light changes from green to yellow. When
100% of the filters rated life is used, the filter indicator light
changes from yellow to red, and it is recommended that you
replace the filter. Use replacement cartridge L400,
part #4396508. 2003 suggested retail price of $32.99 U.S.A./
$49.95 Canada. Prices are subject to change without notice.
The product is for cold water use only.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system.
Refer to the front cover or Assistance or Service section for
the Manufacturers name, address and telephone number.
Refer to the Warranty section for the Manufacturers limited
warranty.
Application Guidelines/Water Supply Parameters
Tested and certified by NSF International against ANSI/NSF Standard
42 for the reduction of Chlorine, Taste and Odor, Particulate Class II*;
and against ANSI/NSF Standard 53 for the reduction of Lead.
Substance Reduction
Aesthetic Effects NSF Reduction
Requirements Average
Influent Influent Challenge
Concentration Maximum
Effluent Average
Effluent Minimum %
Reduction Average %
Reduction NSF Test
Number
Chlorine Taste/Odor
Particulate Class II*50%
85% 2.0 mg/L
833,333/mL 2.0 mg/L ± 10%
At least 10,000
particles/mL
0.03 mg/L
100,000/mL** 0.025 mg/L
40,667/mL 98.5%
88.0% 99.0%
95.1% 504232-01
507163-02
Contaminant
Reduction NSF Reduction
Requirements Average
Influent Influent Challenge
Concentration Maximum
Effluent Average
Effluent Minimum %
Reduction Average %
Reduction NSF Test
Number
Lead: @ pH 6.5
Lead: @ pH 8.5 0.01mg/L
0.01mg/L 0.16 mg/L***
0.15 mg/L*** 0.15 mg/L ± 10%
0.15 mg/L ± 10% 0.001 mg/L
0.001 mg/L 0.001 mg/L
0.001 mg/L 99.35%
99.31% 99.35%
99.31% 507610-01
507611-01
Water Supp ly
Water Pres sure
Water Temperature
Service Flow Rate
City or Well
30 - 120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8° C)
0.5 gpm (1.9 L/min.) @ 60 psi.
*
**
***
Class II particle size: >1 to <5
Test requirement is at least 100,000 particles/mL of AC Fine Test Dust.
These contaminants are not necessarily in your water supply. Performance may vary based on local water conditions.
® NSF is a registered trademark of NSF International.