Whirlpool duet ELECTRONIC ELECTRIC DRYER, ELECTRONIC ELECTRIC DRYER

ElectricalConnection

Power Supply Cord

1. Disconnect power.

2. Remove the hold-down screw and terminal block cover.

Direct Wire

3. Assemble a ³⁄₄" (1.9 cm) UL listed strain relief (UL marking on

strain relief) into the hole below the terminal block opening.

Tighten strain relief screws just enough to hold the two clamp

sections together. Put power supply cord through the strain

relief. The strain relief should have a tight fit with the dryer

cabinet and be in a horizontal position.

4. Now complete installation following instructions for your type

of electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

A. Neutral grounding wire (green/yellow)

B. External ground conductor screw

C. Center, silver-colored terminal block screw

D. Terminal block cover and hold-down screw

WARNING

FireHazard

UseanewULlisted30amppowersupplycord.

UseaULlistedstrainrelief.

Disconnectpowerbeforemakingelectricalconnections.

Connectneutralwire(whiteorcenterwire)tocenter

terminal(silver).

Groundwire(greenorbarewire)mustbeconnectedto

greengroundconnector.

Connectremaining2supplywirestoremaining

2terminals(gold).

Securelytightenallelectricalconnections.

Failuretodosocanresultindeath,fire,or

electricalshock.