Off
L3
$
%
Pull knob and trim ring straight out. Remember how the spring goes.
To remove surface unit, lift and pull straight out.
Cleaning and caring for your range
Your range is designed to be easy to clean. You will usually wipe off spills and spatters when they happen, but you will sometimes want to clean under and behind the control knobs and surface units This section will tell you how to remove those. and what to use when cleaning.
Removing and replacing surface unit control knobs:
1.Be sure the control knobs are set to “OFF”
2.Pull straight out on the black knobs
3.If the control has a chrome trim ring, pull it straight out.
4.Wash the knobs (and trim rings) in warm, sudsy water.
5.Replace the trim rings first. If the control spring was removed, put
it back exactly as shown on the left...small end first.
6.Hold the black knob so it points to “OFF,” Push it straight back on.
Removing and replacing oven control knobs:
1.Be sure the knobs are set to “OFF”
2.Pull each knob straight off.
3.Wash the knobs in warm. sudsy water.
4.The knobs are not interchangeable. Make sure you put the adjust- able Oven Temperature Control Knob on the right place, and the nonadjustable Oven Selector Knob on the other.
Removing surface units and reflector bowls:
1.First. be sure the Surface Unit Controls are all “OFF” and that the surface units are cool.
2.See where the surface units plug into the range? Lift each surface unit about an inch (2.5 cm) at the edge away from the
3.Lift out the reflector bowls.
12
