Wilton FK350-2SX, FK350-4 manual Miter Adjustment, Trip Adjustment FX350-SX, Depth Stop FK350

Miter Adjustment

The adjust the miter position follow the steps below while referring to Figure 10:

1.Move the miter position lock (A) to the right to release.

2.Adjust the head to the desired angle ranging from –45º to +45º by pushing on the back of the motor to the right or left. The miter position is shown on the scale (B).

3.A detent mechanism locks the head in the -45º, 90º and +45º positions and will prevent the head from rotating. For a miter position other than -45º, 90º and +45º, press the lever (C) to release while rotating the head.

4.When the desired cutting angle is set, move miter position lock (A) to the left to secure.

Figure 10

Trip Adjustment – FX350-SX

The height of retract and depth of cut trips set the travel limit of the head.

Te set the trips (refer to Figure 11):

1.Turn the machine on and run in manual mode.

2.Move the head up to the desired height of retract position.

3.Loosen the lock knob (A) and slide the trip

(B)down until it makes contact with the trip plate (C).

4.The trip plate fixes the position mechanically while the limit switch (D) signals the control system.

5.Tighten the lock knob.

6.Move the head down to the desired depth of cut position.

7.Loosen the lock knob (E) and slide the trip

(E)up until it makes contact with the trip plate (not visible in Figure 11).

8.Tighten the lock knob.

Figure 11

Depth Stop – FK350

The depth cut stop adjustment limits the lower travel limit of the saw blade during a cutting operation.

Remove power when making this adjustment.

Failure to comply may result in serious injury!

To adjust the depth of cut (refer to Figure 12):

1.Using two 13mm wrenches, loosen the lock nut (A).

2.With the saw in the fully lowered position, turn the screw (B) until the saw blade bottoms out at the desired level.

3.Tighten the lock nut.

Figure 12

12