Wolf Cinema Owner's Manual
B-21
examples:
NOTE: The 65535 signies the port address of the controller receiving the message.
SynC no longer responding (65535 00030err 001 "System error: SynC no longer
responding")
attempt to delete the current source (65535 00030err 002 "System Warning: The current
source cannot be deleted")
(BDr38900) (65535 00030err 003 "BDr: invalid parameter 1")
(BlB 25 25) (65535 00030err 004 "BlB: Too many parameters")
(aSr S10) (65535 00030err 005 "aSr: Too few parameters")
(aSr S10 1) (65535 00030err 006 "aSr: Source does not exist")
(COn 45) with no source (65535 00030err 007 "COn: Could not be executed")
(&con 64 250) (65535 00030err 008 "COn: Checksum error")
(aBC?) (65535 00030err 009 "aBC: Unknown request")
FaD Fade Time
Use FaD to set the time for dissolving one display image into the next (0=seamless, 100=1
second). Or, if using v1.0 software, FaD sets the time for fading to black and then to the new
display image.
FCs Focus
The FCS adjusts lens focus on projectors having a motorized lens mount, and requires keypad
emulation.
examples:
(FCS K3) –ve Focus direction
(FCS K2) +ve Focus direction.
(FCS K0) Stop focus adjustment (if not issued, lens movement will continue
until it reaches the end stop).
To “nudge” the focus a minimum amount, script in a delay between (FCS K3) and (FCS K0).
Dependingonyourapplication,adelayofatleast20-30millisecondsmaybesufcient.
FIl Input Filter
UseFILtoforceaninternallterforHDTV(1),SDTV(2),EDTV(3),Graphics/RGB(4)ortoturn
theautomaticlteringfeatureoff(0).Thisautomaticlterisforanalogsourcesonly.
Fle Frame lock enable
UseFLEtodenehowtheprojectorcontrolstheoutputframetimingbasedontheinputsignal.
Use the following parameters to achieve the desired output frame timing.
P1 = 0: rate matched – the output runs at close to the input frequency but is not locked to it so
the output will drift in phase relative to the output.
P1 = 1: locked – if possible the output image is phase locked to the input frames
P1 = 2: Free run – the output runs at 60Hz frame rate
For older versions of software (v1.1 and earlier) this control is a checkbox to enable a “locked”
output. When unchecked the output is “Frame matched”.
FMT 2/3 Pull Down Threshold
Use FmT to adjust the threshold (0-255) at which the projector will consider an incoming video
signalaslmvs.video.

3.48 FaD

Fade Time

3.49 FCs

Focus

3.50 FIl

Input Filter

3.51 Fle

Frame lock enable

3.52 FMT

2/3 Pull Down Threshold

AppendixB►SerialCommunications