Wolf Cinema Owner's Manual
B-41
P3 = State/details (opt.) P3 only applies if:
P2 = 1 (Power)
if P3 is 0 = Power Off
if P3 is 1 = Power On
P2 = 2 (error)
P3 = error number
P2 = 5 (Signal input)
P3 = input number
P2 = 6 (Signal Channel)
P3 = Channel number
This optional parameter further
denesthestate.Ifthisis
omitted, assume the event will
reonanysystemeventofthis
type (for example, all signal
input changes rather than a
specicone)
If P1 = F or f Description Meaning
P1 = F or f FUnC key event This is a real-time event that
triggers a command when the
speciedFUNC#ispressed.
P2 = number key 1-5, 7-9 The number to trigger from.
If P1 = X or x Description Meaning
P1 = X or x System event This deletes a stored event.
P2 = Target * = Delete all events
d = Delete all pending events
waiting because of a Dly
command.
number = Delete the event
with the given number from
the list
This parameter determines
which events will be deleted.
examples:
(rTe g 7 H “(GiO 22 P 100)”)
(rTe g 7 H “(GiO 22 P 100) (GiO 1 l)”)
(rTe G 7 H “(GiO 22 P 100) (GiO 1 l)”)
(rTe T 2003/07/09 12:36:45 S "(PWr 1)") = "S" Single / one time
(rTe T 2003/07/09 18:00:00 D "(PWr 0)") = "D" Daily
(rTe T 2003/07/09 05:00:00 W "(PWr 0)") = "W" Weekly
(rTe F 3 “(FrZ 1)”) // freeze image when FUnC-3 pressed
(rTe D 00:05:00 "(PWr 0)") = in 5 minutes, turn the projector off
(rTe G 5 H “(Dly 100) (PWr 0)”) = When pin 5 goes high, delay 100ms, then
power off.
(rTe?)
(rTe!000 T 2003/07/09 05:00:00 S "(PWr 0)")
(rTe!001 T 2003/07/09 12:36:45 S "(PWr 1)")
(rTe!002 T 2003/07/09 18:00:00 D "(PWr 0)")
(rTe?0)
(rTe!000 T 2003/07/09 05:00:00 S "(PWr 0)")
(rTe X 1): delete entry one
(rTe X *): delete all entries
(rTe X d): delete all pending events waiting because of a (Dly) command
AppendixB►SerialCommunications