Wolfgang Puck BBLFP050 manual Using Your Citrus Juicer Attachment

HSN_3n1BlenderManual 6/25/10 11:07 AM Page 17

Using Your

Citrus Juicer Attachment

	1	Place the appliance on a flat, stable, level
		surface where it cannot fall.
	2	Place the Mixing Bowl on the Motor Housing
		with the handle at a 90 degree angle (see
		Figure 6). Rotate the Mixing Bowl clockwise
		as far as possible until you hear it click into
Figure 14		place (See Figure 7).
		Place the Accessory Shaft into the mixing
	3
		bowl over the center hub
	4	Place the assembled citrus juicer
		attachment on top of the mixing bowl with
		the tab of the citrus juicer strainer slightly to
		the right of the bowl handle (See Figure 14).
Figure 15	5	Rotate the citrus juicer strainer until the
		tab lines up with the mixing bowl handle
		(See Figure 15).
	6	Pull the Power Cord out out of the Storage
		Cavity at the rear of the Motor Housing.
		Ensure that the cord is over the larger
		opening in the cord storage area and not in
		the locked position, see Figures 10 and 1 1.
	7	Insert the plug into the wall outlet and turn
		the power switch on the side of the Motor
		Housing to the ON position.

Using Your

Citrus Juicer Attachment cont.

If after plugging the cord in, all indicator lights are flashing, the Mixing Bowl and/or the Lid is not placed correctly on the Motor Housing. For safety reasons it is not

possible to switch on the appliance in Food Processor Mode both Bowl and Lid are properly assembled. Check the position

of the Bowl and the Lid and ensure that it matches Figures 7 & 9. When the Mixing Bowl and the Lid are fitted correctly, only the Standby Indicator Light flashes. Only then can the appliance be operated.

8When processing citrus, we recommend speed I only. Apply steady pressure over reamer. If juicer is not passing through to bowl turn motor off and clean pulp from strainer. You can turn the motor off by pressing the Selected Speed button. Switch the power off by pressing the power switch, located on the right side of the Motor Housing and unplug from the wall outlet.

9When bowl reaches the 3 cup mark turn motor off and pour out contents

10To remove strainer rotate citrus juicer housing slightly to the right (See Figure 14) and lift straight up.

Your electronically-controlled motor comes equipped with an automatic overload protection system which serves two functions:

1)Time Protection: After two minutes of continuous operation, the motor will shut off. Fifteen seconds before switching off, the Standby Indicator Light will begin to flash. This prevents the motor from overheating during use; and

2)Overload Protection: In the event of an electrical overload, the motor will automatically shut off. Simply unplug the unit from the outlet. Wait at least 15 seconds before using again.

Wait at least 15 seconds before using again by pressing the Speed Button to restart.

17 18