Yamaha CP2000 Important Information

Important Information

CP2000—Owner’s Manual

Important Information

• Do not allow water to enter this unit or allow the unit to become wet. Fire or electrical

shock may result.

• Connect this unit’s power cord only to an AC outlet of the type stated in this Owner’s

Manual or as marked on the unit. Failure to do so is a ﬁre and electrical shock hazard.

• Do not scratch, bend, twist, pull, or heat the power cord. A damaged power cord is a

ﬁre and electrical shock hazard.

• Do not place heavy objects, including this unit, on top of the power cord. A damaged

power cord is a ﬁre and electrical shock hazard. In particular, be careful not to place

heavy objects on a power cord covered by a carpet.

• Do not place a container with liquid or small metal objects on top of this unit. Liquid

or metal objects inside this unit are a ﬁre and electrical shock hazard.

• If you notice any abnormality, such as smoke, odor, or noise, or if a foreign object or

liquid gets inside the unit, turn it off immediately. Remove the power cord from the AC

outlet. Consult your dealer for repair. Using the unit in this condition is a ﬁre and elec-

trical shock hazard.

• Should this unit be dropped or the cabinet be damaged, turn the power switch off,

remove the power plug from the AC outlet, and contact your dealer. If you continue

using the unit without heeding this instruction, ﬁre or electrical shock may result.

• If the power cord is damaged (i.e., cut or a bare wire is exposed), ask your dealer for a

replacement. Using the unit with a damaged power cord is a ﬁre and electrical shock hazard.

• Do not remove the unit’s cover. You could receive an electrical shock. If you think inter-

nal inspection, maintenance, or repair is necessary, contact your dealer.

• Do not modify the unit. Doing so is a ﬁre and electrical shock hazard.

•When rack-mounting the unit, allow enough free space around the unit for normal

ventilation. This should be: 10 cm behind, and 2 cm above.

For normal ventilation during use, remove the rear of the rack or open a ventilation hole.

If the airﬂow is not adequate, the unit will heat up inside and may cause a ﬁre.

•This unit has ventilation holes at the front and rear to prevent the internal temperature

rising too high. Do not block them. Blocked ventilation holes are a ﬁre hazard.

•Clean the contacts of the phone plug before connecting it to the SPEAKERS jack of this

unit. Dirty contacts may generate heat.

•Use only speaker cables when connecting speakers to ampliﬁer outputs. Using other

types of cables is a ﬁre hazard.

•Hold the power cord plug when disconnecting it from an AC outlet. Never pull the

cord. A damaged power cord is a potential ﬁre and electrical shock hazard.

•Do not touch the power plug with wet hands. Doing so is a potential electrical shock

hazard.

•Do not use this ampliﬁer for any purpose other than driving loudspeakers.