111
Voice Mode
■Attack Time
Sets the amount of time it takes to reach the peak in
volume from when a note is played. When Attack
Time is set to a positive value, the peak is reached
more slowly. Negative values cause the peak to be
reached more quickly.
❏ Settings: –64~0~+63
■Decay Time
Sets the amount of time it takes to reach the sustain
level from the peak in volume. When Attack Time is
set to a positive value, change occurs more slowly.
Negative values cause change to occur more quickly.
❏ Settings: –64~0~+63
■Sustain Level
Sets the Sustain Level (after the Decay Time is
finished), where the sound remains at a constant
level while the key is pressed.
❏ Settings: –64~0~+63
■Release Time
Sets the amount of time it takes for the sound to
decay to a volume of 0 from when the key is
released. When Release Time is set to a positive
value, the decay occurs more slowly. Negative values
cause the decay to occur more quickly.
❏ Settings: –64~0~+63
[F6]: LFO (Low Frequency Oscillator)
When VL Element is selected, one menu of LFO
parameters is available.
[F8]: LFO (Low Frequency Oscillator)
[F8]: LFO (Low Frequency Oscillator)
Sets the LFO parameters for the VL Element. Applying
LFO modulation to the pitch creates vibrato.
■Vibrato Delay
Sets the delay time from when the keyboard is
played to when the vibrato effect begins. The larger
the value, the longer the delay time before the
vibrato effect begins. Negative values cause the delay
time to be shorter. For more details about Delay, see
page 100.
❏ Settings: –64~0~+63
■Vibrato Speed
Sets the speed of the vibrato effect. The larger the
value, the faster the movement of the vibrato. For
more information about Speed, see page 101.
❏ Settings: –64~0~+63
■Vibrato Depth
Sets the depth of the vibrato. The larger the value,
the deeper the vibrato.
❏ Settings: –64~0~+63
[F7]: CTRL (Controller)
The available menus for the VL Element are as follows:
[F7]: PITCH
[F8]: SET
[F3]: REMAP
[F7]: PITCH
The available parameters are the same as those of the
AWM Element (page 103).
[F8]: SET
“Velocity” is added to the Src (Source) parameter. You
can control Dest (Destination) parameters by keyboard
velocity. The available destination parameters are from
No.126 to the end. For more information, refer to the
Controller List in the separate Data List book.
When you select [F8]: SET, [F3]: REMAP function will
also be added to the screen. The Remap function allows
you to arrange the Voice Controller Sets. For example,
when you have created four Controller Sets, number 1,
3, 4 and 7, the numbers will be ranged from 1 through
4. In addition, pressing the [F3] REMAP may provide
you with recommendable preset Voice Controller Sets
depending on the selected VL voice.
When you press [F3] key to execute the Remap function
without enough vacant Controller Sets, “Can’t set VL
control!” will be displayed indicating that the Remap
function is impossible.
Voice/E.qx 5/21/98 11:30 AM Page 111