145
Voice Mode
■Sample Play
Sets the way in which the sample will be played.
❏ Settings: FwdLp, FwdLpEx, FwdNoLp, RevNoLp, default
For more information about each setting, see page 81.
■Recv Note Off (Receive Note Off)
Sets whether or not MIDI Note Off messages for
each element will be received or ignored.
❏ Settings: receive, ignore
[F7]: MIX
Sets the mix (output) balance for the elements’ samples
which configure a drum voice.
■Drum key
■Drum Layer
■Sample Bank
■Sample Number
These are the same parameters as those explained in
the TUNE screen. See page 143.
■Level
Sets the output level for each element. This setting
adjusts the output balance for each drum/percussion
instrument that make up the drum voice.
❏ Settings: 0~127
■Pan
Sets the left and right positioning of each sound
element in the stereo spectrum. This lets you adjust
the positioning of where each instrument of the
drum voice (drum kit) appears in the stereo
spectrum. When set to “rnd” the sound moves
randomly. You can control the range of movement to
the left or right using the next setting, Random
Depth.
❏ Settings: L63 (far left)~cnt (center)~R63 (far right), rnd
(Random Pan)
■Rev Send (Reverb Send)
Sets the Send level of the signal output from the
Insertion Effects 1/2 (or by-passed) and sent to the
Reverb unit.
❏ Settings: 0~127
The value set here will be multiplied by the value set in
Reverb Send (EFCT screen), and output as an actual
Reverb Send level.
For more information about Effects, see page 148.
■Cho Send (Chorus Send)
Sets the Send level of the signal that output from the
Insertion Effects 1/2 (or by-passed) and sent to the
Chorus unit.
❏ Settings: 0~127
The value set here will be multiplied by the value set in
Chorus Send (EFCT screen), and output as an actual
Chorus Send level.
For more information about Effects, see page 148.
■Random Depth
When you select “rnd” (Random Pan) in Pan, this
parameter is displayed. This function causes the
sound to move randomly in the stereo spectrum. Use
this parameter to set the depth (range) of the
Random Pan.
❏ Settings: 1~127
■ExpLowLimit (Expression Low Limit)
Sets the Expression Low Limit for each sample. The
lower limit can be set so that even when a sound is
played below the set value, the volume will not go
below the designated lower limit.
❏ Settings: 0~127
■Level Vel (Level Velocity)
Sets the velocity level for each sample. The Level
Velocity function controls the volume based on how
hard the keyboard is played. When a positive value is
set, the harder the keyboard is played, the greater the
change in the volume. Negative values will have the
opposite effect.
❏ Settings: –64~0~+63
Voice/E.qx 5/21/98 11:31 AM Page 145