Performance Mode
165
■MIDI Pan/Vol (MIDI Pan/Volume)
Sets the MIDI Pan/Volume to “on” or “off” when
changing to another performance. Pan and Volume
are sent to MIDI [OUT] when set to “on,” and are
not sent when set to “off.”
❏ Settings: on, off
■Rev Send (Reverb Send)
Sets each part’s send level of the signal output from
Insertion Effect (or by-passed) and then sent to the
Reverb unit.
❏ Settings: 0~127
■Cho Send (Chorus Send)
Sets each part’s send level of the signal output from
Insertion Effect (or by-passed) and then sent to the
Chorus unit.
❏ Settings: 0~127
■InsEF Sw (Insertion Effect Switch)
Sets the Insertion Effect unit for each part to “on” or
“off.” The Insertion Effect is used when set to “on,”
and is not used when set to “off.”
❏ Settings: on, off
The type of Insertion Effect is selected in Voice Edit
mode (see page 106).
If you exceed the DSP limitation (page 54), this switch
cannot be turned on. In this case, “DSP resource full”
may appear on the screen.
■Mono/Poly (Monophonic/Polyphonic)
Selects whether the voice is played monophonically
(only one note at a time) or polyphonically (multiple
notes sounding simultaneously).
❏ Settings: mono, poly
■Key Assign
Selects sngl (single) or mlti (multi) Key Assign for
each part. In sngl (single), if the tone generator
receives the same note twice, the first note is
terminated when the same note is subsequently
received. In mlti (multi), when the same notes are
received, sounds are assigned to one channel after
another, making multiple part tone generation
possible.
❏ Settings: sngl, mlti
[F5]: LYR (Layer)
Layer parameters are mainly related to MIDI settings
including the MIDI channel, Arpeggiator on/off, Note
Limit and Velocity for each part. These settings let you
control each part’s MIDI output.
Pressing [F5] Key alternately selects the following two
screens.
Select the appropriate screen for setting each parameter
as required.
• MIDI Signal Graphical Display
• Note/Velocity Limits Graphical Display
■Part
■Bank (Voice Bank)
■Number
These parameters are the same as those explained in
the MIX screen. See page 164.
■1MIDI Ch (MIDI Channel)
Sets the MIDI channel for each part.
❏ Settings: 1~16
■23Trns MIDI A/B (Transmit to MIDI A/B)
Sets the Trns MIDI A/B to “on” or “off.” MIDI data
from the keyboard/controller is sent to each MIDI
output (MIDI OUT A/B) when set to “on,” and is
not sent when set to “off.”
❏ Settings: on, off
Transmit MIDI Out A/B is available for EX5. In the
case of EX5R and EX7, only a set of MIDI Out is
available.
234156
Performance/E/qx 5/21/98 11:35 AM Page 165