55 En
FM/AM tuning
BASIC
OPERATION English
■Automatic station preset
You can use the automatic preset tuning feature to store up
to 40 FM stations with strong signals (A1 to E8: 8 preset
station numbers in each of the 5 preset station groups) in
order.
1Rotate the RINPUT selector (or press
4TUNER) to select “TUNER” as the input
source.
2Press CBAND (or 7BAND) to select “FM”
as the reception band.
“FM” appears in the front panel display.
3Press and hold FMEMORY (or
9MEMORY) for more than 3 seconds.
The preset station number as well as the MEMORY
and AUTO indicators flashes. After approximately 5
seconds, automatic presetting starts from the current
frequency and proceeds toward higher frequencies.
When automatic preset tuning is completed, the
MEMORY indicator disappears.
y
• You can specify the preset number from which this unit stores
FM stations. Press DA/B/C/D/E (or 8A-E/CAT. l / h) and
then EPRESET/TUNING/CH l / h
(or 8PRESET/CH k / n) repeatedly after you perform step 3
to select the preset station number under which the first station
will be stored.
• To cancel the automatic station preset, press FMEMORY (or
9MEMORY) again.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset
station number.
• If the number of received stations does not reach 40 (E8),
automatic preset tuning automatically stops after searching for
all the available stations and copy the stored stations to the rest
preset station numbers.
• Only FM stations with sufficient signal strength are stored
automatically by automatic preset tuning. If the station you
want to store is weak in signal strength or an AM radio station,
tune into it manually and store it as described in “Manual
station preset” below.
■Manual station preset
Use this feature to store the AM or FM stations with weak
signals manually.
1Tune into a station.
See page 53 for tuning instructions.
2Press FMEMORY (or 9MEMORY).
The MEMORY indicator flashes in the front panel
display for approximately 30 seconds.
y
To cancel the preset memory mode, press FMEMORY (or
9MEMORY) again.
3Press EPRESET/TUNING/CH l / h (or
8PRESET/CH k / n) repeatedly to select a
preset station group and number (A1 to E8)
while the MEMORY indicator is flashing.
•Press
Eh (or 8k) to select a higher preset
station group and number.
•Press
El (or 8n) to select a lower preset station
group and number.
y
You can select the preset station group (A to E) by pressing
DA/B/C/D/E (or 8A-E/CAT. l / h) repeatedly.
4Press FMEMORY (or 9MEMORY) while
the MEMORY indicator is flashing.
The station band and frequency appear in the front
panel display with the preset station group and
number you have selected. The MEMORY indicator
disappears from the front panel display.
• Any stored station data existing under a preset station number is
cleared when you store a new station under the same preset
station number.
• The reception mode (stereo or monaural) is stored along with
the station frequency.
Before performing the following operations, press
4
TUNER
on the remote control.
Notes
AUTO
MEMORY
A1:FM 88.9MHz
Flashes
Flash
Notes
MEMORY
Flashes
MEMORY
A1:FM 88.9MHz
The displayed station has been stored as A1.
Flashes