Yamaha P50-m TUNE Controls, UTILITY Controls

2THE CONTROLS OF THE P50-m

TUNE Controls

6 MASTER TUNE button

For adjusting the overall fine tuning of the instrument. (See page 14.)

Also used with the NOTE SHIFT button for playing the Demo song.

(See page 7.)

7 NOTE SHIFT button

For changing the key transposition setting of the instrument. (See

page 15.) Also used with the MASTER TUNE button for playing the

Demo song. (See page 7.)

UTILITY Controls

8 TOUCH button

For changing the touch (velocity) response of the instrument. (See

page 16.) Also for changing the Device Number setting. (See page

19.) Also used with the MIDI CH button for changing the Receive

Mode of the instrument. (See page 20.)

9 MIDI CH (Channel) button

For setting the MIDI Receive channel for the instrument. (See page

17.) Also for setting the MIDI OUT setting. (See page 21.) Also used

with the TOUCH button for changing the Receive Mode of the

instrument. (See page 20.)

10 LED display

11 DATA dial

For adjusting values or changing settings of the various parameters.

12 EQ sliders (LOW, MID, HIGH)

For making fine changes to the tonal quality of the sound. (See page

13.)

6 8 10 11

12

7 9

Contents

Main FCC INFORMATION (U.S.A) * NEDERLAND NETHERLAND ADVARSEL! VARNING VAROITUS SPECIAL MESSAGE SECTION PLEASE KEEP THIS MANUAL Welcome to the P50-m Unpacking iii Table of Contents OPERATION GUIDE APPENDIX SOUND LISTS & MIDI DATA How to Use This Manual 1) Precautions 2) The Controls of the P50-m 3) Setting Up and Playing Your P50-m 4) Operation Guide Precautions LOCATION USE THE CORRECT POWER ADAPTOR MAKE SURE POWER IS OFF WHEN MAKING OR REMOVING CONNECTIONS HANDLE THE INSTRUMENT WITH CARE Page The Controls of the P50-m Front Panel TONE Controls TUNE Controls UTILITY Controls Rear Panel Setting Up and Playing Your P50-m What Youll Need 2. 1. An amplifier/speaker system, preferably stereo. Alternately, you Page Using in Larger MIDI Systems Powering Up and Playing the Demo Song Page Playing all Demo Songs Operation Guide Voice Controls Selecting a Voice 1. 2. Page Tone Controls Changing the Brightness of a Voice 1. 2. Page Page Tune Controls Changing the Master Tune Setting 1. 2. Page Utility Controls Changing the Touch Sensitivity 1. 2. Changing the MIDI Receive Channel 1. 2. Advanced Functions Program Change Table 2. 1. Changing the Device Number 1. 2. Page Changing the MIDI OUT Setting all 2. 1. Factory Set APPENDIX Troubleshooting Page Error Messages Specifications Index Page Page 30 Voice List Effect Lists Effect Type List REVERB CHORUS WHITE ROOM, TUNNEL, BASEMENT Effect-Data Assignment Table table#1 LFO Frequency (Hz) table#2 Modulation Delay Offset (msec) table#3 EQ Frequency (Hz) table#4 Reverb Time (sec) MIDI Data Format 1. Channel voice messages 1.1 Note Off 1.2 Note On / Note Off 1.3 Polyphonic Aftertouch 34 1.5 Program Change 1.6 Channel Aftertouch 1.7 Pitch Bend Change 2. Channel Mode Messages 2.1 All Sound Off 2.2 Reset All Controllers 2.3 All Note Off 2.4 Omni Off 36 3.2 Bulk Dump 4. Realtime Messages 4.1 Active Sensing 5. MIDI thru out 5.1 When MIDI OUT=ot1 5.2 When MIDI OUT=ot2 38 < Table 1-2 > MIDI Parameter Change table ( SYSTEM ) [XG] < Table 1-3 > MIDI Parameter Change table ( EFFECT 1) [XG] < Table 1-4 > MIDI Parameter Change table ( PART ) [XG] 40 < Table 2-2 > MIDI Parameter Change table ( SYSTEM ) [P50-m] Parameter Change Address (H) (M) (L) Address P50-m SYSTEM 00 00 00 < Table 2-1> < Table 2-3 > MIDI Parameter Change table ( REMOTE SWITCH ) [P50-m] MIDI Implementation Chart