Yamaha P50-m Error Messages

APPENDIX

Error Messages

Er1

The battery voltage (for internal memory backup) may be too

low. Bring the unit to your local Yamaha dealer or any other

autorized Yamaha service personnel.

Er2

The address of the received System Exclusive message is

incorrect. Check the address and try transmitting again.

Er3

The data of the received System Exclusive message is incorrect.

Check the data (as to whether it requires an MSB or LSB header)

and try transmitting again.

Er4

The data size of the received System Exclusive message is

incorrect. Check the size of the message and try transmitting

again.

Er5

The checksum of the received System Exclusive message is

incorrect. Check the checksum of the message and try

transmitting again.

Contents

Main FCC INFORMATION (U.S.A) * NEDERLAND NETHERLAND ADVARSEL! VARNING VAROITUS SPECIAL MESSAGE SECTION PLEASE KEEP THIS MANUAL Welcome to the P50-m Unpacking iii Table of Contents OPERATION GUIDE APPENDIX SOUND LISTS & MIDI DATA How to Use This Manual 1) Precautions 2) The Controls of the P50-m 3) Setting Up and Playing Your P50-m 4) Operation Guide Precautions LOCATION USE THE CORRECT POWER ADAPTOR MAKE SURE POWER IS OFF WHEN MAKING OR REMOVING CONNECTIONS HANDLE THE INSTRUMENT WITH CARE Page The Controls of the P50-m Front Panel TONE Controls TUNE Controls UTILITY Controls Rear Panel Setting Up and Playing Your P50-m What Youll Need 2. 1. An amplifier/speaker system, preferably stereo. Alternately, you Page Using in Larger MIDI Systems Powering Up and Playing the Demo Song Page Playing all Demo Songs Operation Guide Voice Controls Selecting a Voice 1. 2. Page Tone Controls Changing the Brightness of a Voice 1. 2. Page Page Tune Controls Changing the Master Tune Setting 1. 2. Page Utility Controls Changing the Touch Sensitivity 1. 2. Changing the MIDI Receive Channel 1. 2. Advanced Functions Program Change Table 2. 1. Changing the Device Number 1. 2. Page Changing the MIDI OUT Setting all 2. 1. Factory Set APPENDIX Troubleshooting Page Error Messages Specifications Index Page Page 30 Voice List Effect Lists Effect Type List REVERB CHORUS WHITE ROOM, TUNNEL, BASEMENT Effect-Data Assignment Table table#1 LFO Frequency (Hz) table#2 Modulation Delay Offset (msec) table#3 EQ Frequency (Hz) table#4 Reverb Time (sec) MIDI Data Format 1. Channel voice messages 1.1 Note Off 1.2 Note On / Note Off 1.3 Polyphonic Aftertouch 34 1.5 Program Change 1.6 Channel Aftertouch 1.7 Pitch Bend Change 2. Channel Mode Messages 2.1 All Sound Off 2.2 Reset All Controllers 2.3 All Note Off 2.4 Omni Off 36 3.2 Bulk Dump 4. Realtime Messages 4.1 Active Sensing 5. MIDI thru out 5.1 When MIDI OUT=ot1 5.2 When MIDI OUT=ot2 38 < Table 1-2 > MIDI Parameter Change table ( SYSTEM ) [XG] < Table 1-3 > MIDI Parameter Change table ( EFFECT 1) [XG] < Table 1-4 > MIDI Parameter Change table ( PART ) [XG] 40 < Table 2-2 > MIDI Parameter Change table ( SYSTEM ) [P50-m] Parameter Change Address (H) (M) (L) Address P50-m SYSTEM 00 00 00 < Table 2-1> < Table 2-3 > MIDI Parameter Change table ( REMOTE SWITCH ) [P50-m] MIDI Implementation Chart