Status indicators (LED)Indicate the status of this unit and Bluetooth connection.

When the power is on, the status indicator (Green) lights up. When / (volume) on the unit is pressed, it blinks once. The status indicator (Blue) lights up to show that Bluetooth is connected and blinks when disconnected.

The status indicator (Green) does not blink when the unit’s volume reaches minimum or maximum value, or when the volume is not adjustable.

Status

 

LED

 

Green

 

Blue
Bluetooth connection not establishedLight up

 

Blinking slowly
(Auto Connection)

 

 

(once every 5 seconds)

 

 

 

 

Bluetooth connection not established

Light up

 

Blinking quickly
(Waiting Status)

 

 

(twice every 5 seconds)

 

 

 

 

Bluetooth connection established

Light up

 

Light up

Clearing all the pairing data

Light up

 

Blinking quickly

 

 

 

(for about 3 seconds)
Batteries are weak

Blinking slowly

 

–

Troubleshooting

Refer to the table below if the unit does not operate properly. If the problem you are experiencing is not listed below, or if the instruction below does not help, turn off the unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center.

General

Problem

Cause

Remedy

 

The connection between this unit and the other

Connect the cable properly, or establish Bluetooth

 

component is not correct.

connection again.

 

 

 

No sound.

The volume of this unit or other component is set

Increase the volume level for both this unit and other

to the minimum.

component.

 

 

 

 

 

AC adaptor is not connected correctly.

Connect AC adaptor correctly.

 

 

 

 

The batteries are weak.

Replace all batteries.

 

 

 

Even if the volume level is raised,

The protection circuitry has been activated by

Reduce the volume level.

excessive volume.

 

the sound level does not increase.

 

 

 

The volume of the other component is low.

Increase the volume level of other component.

 

 

 

 

The status indicator (Green) is

The batteries are weak.

Replace all batteries.

Others

Problem

Cause

 

 

Remedy

Bluetooth connection cannot

The unit is in power-saving mode.

Power on the unit and perform Bluetooth connection.

be established when the unit is

 

 

 

 

powered off, even if the AC adaptor

 

 

 

 

is connected.

 

 

 

 

 

 

 

 

 

 

The volume of the other component is low.

Increase the volume level of other component.

Auto power on does not work.

 

 

 

 

The played audio is too short.

This unit does not power on if the duration of the sound is

 

 

short, such as a click.

 

 

 

 

 

The unit powered off automatically.

Auto power off has occurred.

Press

 

(power) to turn this unit on.

 

Refer to "Auto power off" under "Power (Power

 

 

 

 

 

on/off)."

 

 

 

 

 

 

 

 

Auto power off does not work.

The cable is connected to the AUX connector.

Disconnect the cable from AUX connector.

 

 

 

 

 

CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.

There is a chance that placing this unit too close to a CRT- based (Braun tube) TV set might impair picture color. Should this happen, move this unit away from the TV set.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

This unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this unit itself is turned off. In this state, this unit is designed to consume a very small quantity of power.

CAUTION
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT

THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE: Blue: NEUTRAL

Brown: LIVE

As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth terminal of the three pin plug.

blinking slowly.

 

 

 

 

 

 

 

 

 

This unit does not work at all.

Reset the unit.

Press and hold the

 

(power) on the unit for more than

 

 

 

 

10 seconds.

 

 

 

 

 

 

When using the Bluetooth connection

Problem

Cause

Remedy

 

The other component does not support A2DP.

Perform pairing operations with a component which

 

 

supports A2DP.

 

 

 

 

A Bluetooth adaptor, etc. that you want to pair

Use a Bluetooth adaptor, etc. whose passkey is “0000”.

 

with this unit has a passkey other than “0000”.

 

 

 

 

 

Wrong distance.

Reposition this unit within 10 m (33 ft) range from the

Cannot make this unit paired with

 

other component.

the other component.

There is a device (microwave oven, wireless

Reposition this unit.

 

LAN, etc.) outputs signals in the 2.4 GHz

 

 

frequency band nearby.

 

 

 

 

 

The unit is in power-saving mode.

Power on the unit and perform Bluetooth connection.

 

 

 

 

Bluetooth connection is already established with

Disconnect Bluetooth connection with another component.

 

another component.

 

 

 

 

 

The other component is not connected to this unit

Perform Bluetooth connection (☞ 3 En).

 

by Bluetooth.

 

 

 

 

 

Wrong distance.

Reposition this unit within 10 m (33 ft) range from the

 

 

other component.

 

 

 

 

There is a device (microwave oven, wireless

Reposition this unit.

 

LAN, etc.) outputs signals in the 2.4 GHz

 

 

frequency band nearby.

 

 

 

 

No sound is produced or the sound

The other component’s Bluetooth function is not

Check that the Bluetooth function of the other component

enabled.

is set properly.

is interrupted during playback.

 

 

This unit is not registered on the other

Perform pairing operations again.

 

 

component’s Bluetooth device list.

 

 

 

 

 

The other component is not set to send Bluetooth

Check that the Bluetooth function of the other component

 

audio signals to this unit.

is set properly.

 

 

 

 

The pairing setting of the other component is not

Set the pairing setting of the other component to this unit.

 

set to this unit.

 

 

 

 

 

The other component’s volume is set to the

Increase the volume level of the other component.

 

minimum.

 

 

 

 

To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.

1Install this unit in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. (Do not use/keep this unit in a car etc.)

2Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds.

3Do not expose this unit to sudden temperature changes from cold to hot, and do not locate this unit in an environment with high humidity (i.e. a room with a humidifier) to prevent condensation inside this unit, which may cause an electrical shock, fire, damage to this unit, and/or personal injury.

4Avoid installing this unit where foreign objects may fall onto this unit and/or this unit may be exposed to liquid dripping or splashing. On the top of this unit, do NOT place:

−Other components, as they may cause damage and/or discoloration on the surface of this unit.

−Burning objects (i.e. candles), as they may cause fire, damage to this unit, and/or personal injury.

−Containers with liquid in them, as they may fall and liquid may cause electrical shock to the user and/or damage to this unit.

5Do not cover this unit with a newspaper, tablecloth, curtain, etc. in order not to obstruct heat radiation. If the temperature inside this unit rises, it may cause fire, damage to this unit, and/or personal injury.

6Do not operate this unit upside-down. They may overheat, possibly causing damage.

7Do not use force on switches, knobs, and/or cords.

8When disconnecting the power cable from the wall outlet, grasp the AC plug; do not pull the cord.

9Do not clean this unit with chemical solvents; this might damage the finish. Use a clean, dry cloth.

10Only the voltage specified on this unit must be used. Using this unit with a higher voltage than specified is dangerous and may cause fire, damage to this unit, and/or personal injury. Yamaha will not be held responsible for any damage resulting from use of this unit with a voltage other than that specified.

11Do not attempt to modify or fix this unit. Contact qualified Yamaha service personnel when any service is needed. The cabinet should never be opened for any reason.

12When not planning to use this unit for long periods of time (i.e. when going on vacation), disconnect the power cable from the AC wall outlet.

13Be sure to read the “TROUBLESHOOTING” section regarding common operating errors before concluding that the unit is faulty.

14Before moving this unit, disconnect the power cable from the wall outlet.

15Be sure to use the AC adaptor supplied with this unit. Using an AC adaptor other than the one provided may cause fire or damage to this unit.

16Install this unit near the wall outlet and where the power cable can be reached easily.

17For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet.

This will prevent damage to the product due to lightning and power-line surges.

18The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

–Keep the batteries in a location out of reach of children. Batteries can be dangerous if a child were to put in his or her mouth.

–If the batteries grow old, the effective operation range of the remote control decreases considerably. If this happens, replace the batteries as soon as possible.

–Do not use old batteries together with new ones.

–Do not use different types of batteries (such as alkaline and manganese batteries) together. Read the packaging carefully as these different types of batteries may have the same shape and color.

–Exhausted batteries may leak. If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

–If you plan not to use the unit for a long period of time, remove the batteries from the unit. Otherwise, the batteries will wear out, possibly resulting in a leakage of battery liquid that may damage the unit.

–Do not throw away batteries with general house waste. Dispose of them correctly in accordance with your local regulations.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

For U.K. customers

If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an appropriate 3 pin plug fitted. For details, refer to the instructions described below.

Note

The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is hazardous if engaged in a live socket outlet.

AVEEA71102A

Important Notice: Guarantee Information for customers in EEA* and Switzerland

For detailed guarantee information about this Yamaha product, and Pan-EEA* and Switzerland warranty service, please either visit the website address below (Printable file is available at our website) or contact the Yamaha representative office for your country. * EEA: European Economic Area (http://europe.yamaha.com/warranty/)

Radio waves may affect electro-medical devices.Do not use this unit near medical devices or inside medical facilities.

Do not use this unit within 22 cm (9 inches) of persons with a heart pacemaker implant or defibrillator implant.

We, Yamaha Music Europe GmbH hereby declare that this unit is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.

Yamaha Music Europe GmbHSiemensstr. 22-34 25462 Rellingen, GermanyTel: +49-4101-303-0

Information for Users on Collection and Disposal of Old Equipment and used Batteries

These symbols specified in the Directives 2002/96/EC and 2006/66/EC indicate that used electrical and electronic products and batteries should not be mixed with general household waste.

For proper treatment to avoid harmful effect on human health and environment, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.

Note for the battery symbol (bottom two symbol examples):

This symbol might be used in combination with a chemical symbol. In this case it complies with the requirement set by the Directive for the chemical involved.

4 Eni Enii Eniii En