3
Touring the RC-D24
RC-D24—Owner’s Manual
B
Quarter-note indicator
This indicator lights up when the D24 is set to display MIDI Clock information instead
of SMPTE/EBU timecode. This indicator works only if supported by the D24 system
software.
C
Counter
The counter shows the current position in hours,
minutes, seconds, and frames (00:00:00.00).
D
Message area
The message area of the display more or less corresponds to the 2nd line of the D24’s
display, and shows captured positions, locate point positions, project numbers, locate
memory numbers, take numbers, remote unit IDs, and tracks selected for recording.
Time information is displayed in hours, minutes, seconds, frames, and sub-frames
(00:00:00.00.0).
LAST REC IN, LAST REC OUT, A, and B point val-
ues are identified using the prefixes shown here.
Transport Controls
A
A & B buttons & indicators
These buttons are used to set and locate the A and B points. The A and B indicators light
up when the respective A or B point is set.
B
ROLL BACK button
This button is used to roll back from the current position in steps of between 1 and 30
seconds, the default being 5 seconds.
Hour Min Sec fr sub-fr
Hour Min Sec fr
FSMH
SFmsM
H
00 00 00 00
00 0 0 0 0 0 0 0 0 0 0
— LAST REC IN point
— LAST REC OUT point
— A point
— B point
8
9
6
7
J K L M N
3
1
4
2
5
PROJECT SEARCH
RTN TO
ZERO
REW FF STOP PLAY REC
ROLL
BACK
LAST REC SET
REPEAT
A B REHE
AUTO
PUNCH
B
A
IN OUT