Caution: Read this before operating your unit

1To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.

2Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the unit to rain or water.

3Do not operate the unit upside-down. It may overheat, possibly causing damage.

4Never open the cabinet. If something drops into the set, contact your dealer.

5Do not use force on switches, controls or connection wires. When moving the unit, first disconnect the power plug and the wires connected to other equipment. Never pull the wires themselves.

6Do not attempt to clean the unit with chemical solvents; this might damage the finish. Use a clean, dry cloth.

7Always set the VOLUME control to “–∞” before starting the audio source play. Increase the volume gradually to an appropriate level after the play back has been started.

8To prevent lightning damage, pull out the power cord and remove the antenna cable during an electrical storm.

9Be sure to read the “TROUBLESHOOTING” section regarding common operating errors before concluding that the unit is faulty.

10AC outlet

Do not connect audio equipment to the AC outlet on the rear panel if that equipment requires more power than the outlet is rated to provide.

FCC INFORMATION

1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!

Compliance with FCC regulations does not guarantee that

This product, when installed as indicated in the

interference will not occur in all installations. If this product

instructions contained in this manual, meets FCC

is found to be the source of interference, which can be

requirements. Modifications not expressly approved by

determined by turning the unit “OFF” and “ON”, please try

Yamaha may void your authority, granted by the FCC, to

to eliminate the problem by using one of the following

use the product.

measures:

2. IMPORTANT : When connecting this product to

Relocate either this product or the device that is being

accessories and/or another product use only high quality

affected by the interference.

shielded cables. Cable/s supplied with this product

Utilize power outlets that are on different branch (circuit

MUST be used. Follow all installation instructions.

breaker or fuse) circuits or install AC line filter/s.

Failure to follow instructions could void your FCC

 

authorization to use this product in the USA.

In the case of radio or TV interference, relocate/reorient the

3. NOTE : This product has been tested and found to

antenna. If the antenna lead-in is 300 ohm ribbon lead,

comply with the requirements listed in FCC Regulations,

change the lead-in to coaxial type cable.

Part 15 for Class “B” digital devices. Compliance with

If these corrective measures do not produce satisfactory

these requirements provides a reasonable level of

results, please contact the local retailer authorized to

assurance that your use of this product in a residential

distribute this type of product. If you can not locate the

environment will not result in harmful interference with

appropriate retailer, please contact Yamaha Electronics

other electronic devices.

Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA

This equipment generates/uses radio frequencies and, if

90620.

not installed and used according to the instructions

The above statements apply ONLY to those products

found in the users manual, may cause interference

distributed by Yamaha Corporation of America or its

harmful to the operation of other electronic devices.

subsidiaries.

 

SUPPLIED ACCESSORIES

After unpacking, check that the following parts are contained.

● Remote Control Transmitter

● Batteries (size AA, R6, UM-3)

● AM Loop Antenna

●Indoor FM Antenna

3