USING MULTI-ZONE CONFIGURATION
101 En
ADVANCED
OPERATION
This unit allows you to configure a multi-zone audio system. The Zone 2 feature allows you to set this unit to reproduce
separate input sources in the main zone and the second zone (Zone 2). You can control this unit from the second zone
using the supplied remote control.
You need the following additional equipment to use the multi-zone functions of this unit:
• An infrared signal receiver in the second zone.
• An infrared signal emitter in the main zone. This emitter transmits the infrared signals from the remote control via the
infrared signal receiver in the second zone to a CD player or a DVD player, etc. in the main zone.
• An amplifier and speakers in the second zone.
y
• Since there are many possible ways to connect and use this unit in a multi-zone configuration, we recommend that you consult with
your nearest authorized YAMAHA dealer or service center about the Zone 2 connections that best meet your requirements.
• Some YAMAHA models are able to connect directly to the REMOTE jacks of this unit. If you own these products, you may not need
to use an infrared signal emitter. Up to 6 YAMAHA components can be connected as shown below.
■Multi-zone configuration and Zone 2 connections
• When you do not use the main zone, press MAIN ZONE ON/OFF on the front panel to turn off the main zone.
• To avoid unexpected noise, DO NOT USE the Zone 2 feature with CDs encoded in DTS.
USING MULTI-ZONE CONFIGURATION
Only analog signals are sent to the second zone. Any source you want to listen to in the second zone must be
connected to the analog AUDIO IN jacks of this unit.
Connecting Zone 2
Notes
REMOTE OUTREMOTE OUTREMOTE OUT REMOTE OUT
REMOTE INREMOTE INREMOTE IN
REMOTE IN
This unit YAMAHA
component
YAMA HA
component
Infrared signal
receiver
REMOTE OUT
AUDIO IN
VIDEO IN
MONITOR OUT
SP OUT
REMOTE IN
ZONE 2 OUTPUT
MAIN ZONE
ZONE 2
Infrared signal emitter
DVD player
Amplifier
Remote control
Infrared signal receiver
Second zoneMain zone
This unit