20
Setting the unit to match your
speaker system
Follow the instructions below to set the amplifier output
to match the size of your room and speakers. Press u / d
to cycle through parameters 1 through 4, and j / i to alter
the parameter setting.
Factory default settings are highlighted.
1ROOM
Settings: S, M, L
Select the size of the room you have installed your
speakers in. Roughly speaking, the room sizes are
defined as follows:
[U.S.A. and Canada models]
S: 16 x 13 ft, 200 ft2 (4.8 x 4.0 m, 20 m2)
M: 20 x 16 ft, 300 ft2 (6.3 x 5.0 m, 30 m2 )
L: 26 x 19 ft, 450 ft2 (7.9 x 5.8 m, 45 m2 )
[Other models]
S: 3.6 x 2.8 m, 10 m2
M: 4.8 x 4.0 m, 20 m2
L: 6.3 x 5.0 m, 30 m2
2SUBWOOFER
Settings: YES, NONE
Select YES if you have a subwoofer in your system,
or NONE if you do not.
3SPEAKERS
Settings: 2, 3, 4, 5 (spk)
Select the number of speakers connected in your
speaker configuration. This number does not include
your subwoofer.
BASIC SYSTEM SETTINGS
4SET or CANCEL
Select SET to confirm the changes you made. Select
CANCEL to exit SETUP MENU without altering any
of the unit settings. The unit will output a test tone to
the speakers (see 5).
5Use the test tone to check the speaker levels.
When you select SET in 4, the display changes to
“CHECK : Test Tone” for a few seconds, and the unit
outputs a test tone to each of the speakers in turn
twice. When the test tone begins, the display changes
to “CHECK OK?--YES”.
If the test tone is output at the same volume from all
of the speakers, select “CHECK OK: YES”. Press d
to exit from the SETUP menu.
If the volume of the test tone varies between speakers,
press j / i to change the display to “NO”.
Note
• The indicator of the speaker currently outputting the test tone
flashes on the front panel display.
2 SP LEVEL
(Setting speaker output levels)
Use this menu to compare and adjust the test tone output
from each speaker to the output from the front left (or
surround left) speaker so that the volume level for all
speakers is identical. Press u / d to select a speaker,
then adjust the balance using j / i.
Note
• The unit outputs the test tone from the selected speaker and
the front left (or surround left) speaker in turn. The indicator
of the speaker currently outputting the test tone flashes on the
front panel display.
L-R
Adjust the balance between the front left and right
speakers.
C
Adjust the balance between the front left and center
speakers.
SL
Adjust the balance between the front left and
surround left speakers.
SR
Adjust the balance between the surround left and
surround right speakers.
SWFR
Adjust the balance between the front left speaker and
the subwoofer.
Setting
2spk
3spk
4spk
5spk
Display
L R
L C R
L R
SL SR
L C R
SL SR
Speaker
Front L/R
Front L/R,
Center
Front L/R,
Surround L/R
Front L/R, Center,
Surround L/R
RX-V350_WC76800_18-20_EN.p65 03.12.25, 2:37 PM20